退火对热老化308L不锈钢焊材显微结构的影响
Effect of Annealing on Microstructure of Thermally Aged 308L Stainless Steel Weld Metal
查看参考文献54篇
文摘
|
对410℃下热老化7000h的308L不锈钢焊材进行了550 ℃、1h的退火处理,利用TEM和三维原子探针研究了退火对热老化焊材显微结构的影响,并与未热老化试样进行比较,评价退火回复效果。结果表明,退火后奥氏体无明显变化,而δ铁素体内由热老化导致的调幅分解完全消失,且G相显著减少。此外,热老化导致Ni、Mn、C在δ铁素体/奥氏体相界处发生偏聚,而对相界处Cr、Si、P元素的含量无明显影响。退火后相界处所有元素均无偏聚,但会导致Ni、Mn在靠近相界的奥氏体一侧发生富集。退火后308L不锈钢焊材的显微结构接近于未热老化状态,表明退火回复效果显著。 |
其他语种文摘
|
Austenitic stainless steel weld metal has been widely used as nozzle/safe-end joint and inner surface cladding of reactor pressure vessel, due to its good mechanical property and corrosion resistance. However, long-term thermal ageing at the service temperature (280-330℃) could induce hardening and embrittlement of the weld metal. To recover the thermal ageing embrittlement, the annealing treatment has been proposed since the annealing could affect the ageing-induced microstructural changes such as spinodal decomposition and G-phase precipitation in ferrite. However, there is still an incomplete understanding as well as a lack of nanoscale investigation about the annealing effect on the microstructural change of the weld metal. In this work, 308L stainless steel weld metal was thermally aged at 410 ℃for 7000 h, followed by an annealing treatment at 550 ℃ for 1 h. Since the weld metal has a dual-phase structure of austenite and δ-ferrite, the phase transformation of austenite and δ-ferrite as well as the ele ment segregation at the δ-ferrite/austenite phase boundary were investigated by TEM and atom probe tomography. The results revealed that austenite was unaffected by annealing while the ageing-induced spinodal decomposition of δ-ferrite was completely recovered. In addition, the number density of G phase in δ-ferrite was significantly reduced following annealing. This indicates that austenite has a higher stability compared with δ-ferrite. As for the δ-ferrite/austenite phase boundary, thermal ageing induced the segregation of Ni, Mn and C at the phase boundary, while the contents of Cr, Si and P remained almost unchanged. Following the annealing treatment, the segregation of all elements was eliminated. Further, only a small quantity of Ni and Mn was enriched in austenite near the phase boundary. The results suggested that the microstructure of the annealed specimen was similar to that of the unaged specimen, indicating a good recovery of the microstructure by annealing. |
来源
|
金属学报
,2019,55(5):555-565 【核心库】
|
DOI
|
10.11900/0412.1961.2018.00365
|
关键词
|
不锈钢焊材
;
热老化
;
退火
;
调幅分解
;
G相析出
;
相界偏聚
|
地址
|
1.
中国科学院金属研究所, 中国科学院核用材料与安全性评价重点实验室, 沈阳, 110016
2.
中国科学技术大学材料科学与工程学院, 沈阳, 110016
3.
苏州热工研究院有限公司, 苏州, 215004
|
语种
|
中文 |
文献类型
|
研究性论文 |
ISSN
|
0412-1961 |
学科
|
金属学与金属工艺 |
基金
|
国家自然科学基金
|
文献收藏号
|
CSCD:6488959
|
参考文献 共
54
共3页
|
1.
Ma C. Effect of polishing process on corrosion behavior of 308L stainless steel in high temperature water.
Appl. Surf. Sci,2018,442:423
|
CSCD被引
5
次
|
|
|
|
2.
Delong W T. Ferrite in austenitic stainless steel weld metal.
Weld. J,1974,53:273s
|
CSCD被引
7
次
|
|
|
|
3.
Rao K P. Corrosion behavior of austenitic weld and clad metals in accelerated boiling acid tests simulating passive conditions.
Corrosion,1986,42:1
|
CSCD被引
1
次
|
|
|
|
4.
Dong L J. Environmentally assisted crack growth in 308L stainless steel weld metal in simulated primary water.
Corros. Sci,2017,117:1
|
CSCD被引
7
次
|
|
|
|
5.
Lee J S. Microstructural characteristics and embrittlement phenomena in neutron irradiated 309L stainless steel RPV clad.
J. Nucl. Mater,2004,326:38
|
CSCD被引
3
次
|
|
|
|
6.
Chung H M. Embrittlement of laboratory and reactor aged CF3,CF8, and CF8M duplex stainless steels.
Mater. Sci. Technol,1990,6:249
|
CSCD被引
13
次
|
|
|
|
7.
Li S L. G-phase precipitation in duplex stainless steels after long-term thermal aging: A high-resolution transmission electron microscopy study.
J. Nucl. Mater,2014,452:382
|
CSCD被引
6
次
|
|
|
|
8.
Takeuchi T. Study on microstructural changes in thermally-aged stainless steel weld-overlay cladding of nuclear reactor pressure vessels by atom probe tomography.
J. Nucl. Mater,2011,415:198
|
CSCD被引
7
次
|
|
|
|
9.
Alexander K B. Microscopical evaluation of low temperature aging of type 308 stainless steel weldments.
Mater. Sci. Technol,1990,6:314
|
CSCD被引
3
次
|
|
|
|
10.
Danoix F. Hardening of aged duplex stainless steels by spinodal decomposition.
Microsc. Microanal,2004,10:349
|
CSCD被引
7
次
|
|
|
|
11.
Cao X Y. An investigation on microstructure and mechanical property of thermally aged stainless steel weld overlay cladding.
J. Nucl. Mater,2017,486:172
|
CSCD被引
4
次
|
|
|
|
12.
Takeuchi T. Effects of thermal aging on microstructure and hardness of stainless steel weld-overlay claddings of nuclear reactor pressure vessels.
J. Nucl. Mater,2014,452:235
|
CSCD被引
5
次
|
|
|
|
13.
Jang H. The effects of reversion heat treatment on the recovery of thermal aging embrittlement of CF8M cast stainless steels.
Mater. Des,2014,56:517
|
CSCD被引
2
次
|
|
|
|
14.
Li S L. Annealing induced recovery of long-term thermal aging embrittlement in a duplex stainless steel.
Mater. Sci. Eng. A,2013,564:85
|
CSCD被引
9
次
|
|
|
|
15.
Mateo A. Mechanical evaluation of a reversion heat treatment for a duplex stainless steel thermally embrittled.
Proceedings of the 11th Biennial European Conference on Fracture,1996:779
|
CSCD被引
1
次
|
|
|
|
16.
Brooks J A. Microstructural development and solidification cracking susceptibility of austenitic stainless steel welds.
Int. Mater. Rev,1991,36:16
|
CSCD被引
17
次
|
|
|
|
17.
Long C J. The ferrite content of austenitic stainless steel weld metal.
Weld. J,1973,52:281S
|
CSCD被引
2
次
|
|
|
|
18.
Natesh M. Effect of reversion heat treatment on the mechanical properties of thermally embrittled UNS S32760 duplex stainless steel.
Mater. Sci. Forum,2015,830/831:127
|
CSCD被引
1
次
|
|
|
|
19.
Shamanth V. Dissolution of alpha-prime precipitates in thermally embrittled S2205-duplex steels during reversionheat treatment.
Results Phys,2015,5:297
|
CSCD被引
3
次
|
|
|
|
20.
Chung H M. Aging and life prediction of cast duplex stainless steel components.
Int. J. Pres. Ves. Pip,1992,50:179
|
CSCD被引
36
次
|
|
|
|
|