Influence of temperature rate on transitory internal friction during reverse martensitic transformation for Ti_(50)Ni_(27)Cu_(23) alloy
查看参考文献16篇
|
文摘
|
Internal friction (IF) spectra during reverse martensitic transformation from 35 to 135℃ at different temperature rates of 0.5, 0.75, and 1℃/min for Ti_(50)Ni_(27)Cu_(23) shape memory alloy (SMA) samples were measured with a dynamic mechanical analyzer, respectively. The IF spectra were characterized by IF peak increasing progressively and peak shifting toward high temperature with an increase in temperature rate. An iterative approach was used to calculate the precise intrinsic and approximate transitory IF contributions to the normal IF spectrum. The quantitatively analyzed results indicate that the transitory IF of this alloy is nonlinearly dependent on the temperature rate and obeys a power law with a power coefficient of 0.55. The predicted and experimental IF spectra at different temperature rates of 0.75 and 1℃/min agree well with each other, respectively. |
|
来源
|
Rare Metals
,2010,29(3):308-311 【核心库】
|
|
DOI
|
10.1007/s12598-010-0054-y
|
|
关键词
|
internal friction
;
shape memory alloy
;
TiNiCu alloy
;
temperature rate
;
reverse martensitic transformation
|
|
地址
|
School of Materials Science and Engineering, Shenyang Ligong University, Shenyang, 110159
|
|
语种
|
英文 |
|
文献类型
|
研究性论文 |
|
ISSN
|
1001-0521 |
|
学科
|
金属学与金属工艺 |
|
文献收藏号
|
CSCD:3892538
|
参考文献 共
16
共1页
|
|
1.
Humbeeck JV. Damping capacity of thermoelastic martensite in shape memory alloys.
J. Alloys Compd,2003,355:58
|
CSCD被引
35
次
|
|
|
|
|
2.
Cai W. Damping behavior of TiNi based shape memory alloys.
Mater. Sci. Eng. A,2005,394:78
|
CSCD被引
10
次
|
|
|
|
|
3.
Wu SK. Damping characteristics of TiNi binary and ternary shape memory alloys.
J. Alloys Compd,2003,355:72
|
CSCD被引
1
次
|
|
|
|
|
4.
Mazzolai FM. Internal friction spectra of the Ni_(40)Ti_(50)Cu_(10) shape memory alloy charged with hydrogen.
Acta Mater,2003,51(2):573
|
CSCD被引
2
次
|
|
|
|
|
5.
Biscarini A. Diffusion of hydrogen in the shape memory alloy Ni_(47)Ti_(40)Hf_(10)Cu_3.
J. Alloys Compd,2005,404:261
|
CSCD被引
1
次
|
|
|
|
|
6.
Yoshida I. Damping properties of Ti_(50)Ni_(50-x)Cu_x alloys utilizing martensitic transformation.
J. Alloys Compd,2003,355:79
|
CSCD被引
6
次
|
|
|
|
|
7.
Li YH. Analysis of the internal friction spectrum of TiNiCu alloy.
J Alloys Compd,2007,430:149
|
CSCD被引
1
次
|
|
|
|
|
8.
Nam TH. Shape Memory Characteristics and Lattice Deformation in Ti-Ni-Cu Alloys.
Mater Trans,1990,31:1050
|
CSCD被引
1
次
|
|
|
|
|
9.
Li YH. Temperature memory effect of Ti_(50)Ni_(30)Cu_(20) (at.%) alloy.
J. Alloys Compd,2005,400:112
|
CSCD被引
1
次
|
|
|
|
|
10.
Dejonghe W. Factors affecting the internal friction peak due to thermoelastic martensitic transformation.
Scripta Metall,1976,10(12):1125
|
CSCD被引
12
次
|
|
|
|
|
11.
Bidaux JE. Internal friction associated with the allotropic transformation of cobalt.
J Phys. C,1985,46(10):601
|
CSCD被引
1
次
|
|
|
|
|
12.
Juan J San. Damping behavior during martensitic transformation in shape memory alloys.
J. Alloys Compd,2003,355:65
|
CSCD被引
10
次
|
|
|
|
|
13.
Pérez-Sáez RB. Anelastic contributions and transformed volume fraction during thermoelastic martensitic transformations.
Phys. Rev. B,1998,57:5684
|
CSCD被引
2
次
|
|
|
|
|
14.
Pérez-Sáez RB. Analysis of the internal friction spectra during martensitic transformation by a new temperature rate method.
J. Alloys Compd,2000,310:334
|
CSCD被引
2
次
|
|
|
|
|
15.
Zhang JX. Dissipation function of the first-order phase transformation in solids via internal-friction measurements.
Phys. Rev. B,1995,52:268
|
CSCD被引
21
次
|
|
|
|
|
16.
Wang YN. Recent studies on internal friction associated with diffusionless phase transitions and domain walls.
Proceedings of the ICIFUAS-9,1990:305
|
CSCD被引
1
次
|
|
|
|
|
了解气象卫星更多信息，请访问