高应变速率下Mg-3Zn-1Y镁合金的各向异性及变形机制
Anisotropy and Deformation Mechanisms of As-Extruded Mg-3Zn-1Y Magnesium Alloy Under High Strain Rates
查看参考文献27篇
|
文摘
|
采用分离式Hopkinson压杆装置(SHPB)测试了挤压态Mg-3Zn-1Y稀土镁合金在应变速率分别为1000、 1500和2200 s~(-1)时的动态真应力-真应变曲线;采用OM和SEM等分析了其高速变形过程中的组织演变规律及断口形貌,从微观变形机制的角度探讨了具有强烈初始基面织构的挤压态镁合金产生各向异性的原因。分析结果表明:在高速变形条件下,由于加载方向不同,挤压态Mg-3Zn-1Y镁合金的压缩行为表现出较明显的各向异性。挤压态Mg-3Zn-1Y镁合金宏观上的各向异性是由于不同的微观变形机制所引起的。沿挤压方向压缩时,当应变较小时,变形机制主要为拉伸孪晶,当应变增加时,会有柱面滑移参与变形,当应变达到一定值时滑移成为其主要的变形方式。而沿挤压横向压缩时,随着应变速率增加,变形方式由压缩孪生为主变为基面滑移和二次锥面滑移协同变形。 |
|
其他语种文摘
|
As a very important design principle,the dynamic properties of materials attracted extensive attention in resent years and a bunch of works have been done concerning with the materials deformation behaviors under high strain rates.However,the dynamic behaviors of magnesium alloys are not through understood,especially the rare earth based magnesium alloys.In order to investigate the dynamic and anisotropic behavior under high strain rates deformation of as-extruded Mg-3Zn-1Y magnesium alloy,the split Hopkinson pressure bar (SHPB) apparatus was used to testing the true stress-true strain curves under the high strain rates of 1000,1500 and 2200 s~(-1) of as-extruded Mg-3Zn-1Y magnesium alloy.The OM and SEM were used to analysis the micorstructure evolution and fracture surface morphology of the alloy.The true reason behind the anisotropic phenomenon was revealed based on the deformation mechanism of highly basal-textured magnesium alloy.The results demonstrate that the as-extruded Mg-3Zn-1Y magnesium alloy exhibits pronounced anisotropy during compression according to the loading direction.The anisotropy of the as-extruded Mg-3Zn-1Y magnesium alloy are arised from the variety of the deformation mechanisms.When the loading direction is along extrusion direction,the predominant deformation mode changes from extension twinning at a lower strain to prismatic slip at a higher strain.While compressed along extrusion radial direction (ERD),the predominant deformation mode changes from contraction twinning to a coordination of basal and second order pyramidal slip with the increasing of strain. |
|
来源
|
金属学报
,2018,54(4):557-565 【核心库】
|
|
DOI
|
10.11900/0412.1961.2017.00147
|
|
关键词
|
镁合金
;
各向异性
;
高应变速率
;
变形机制
|
|
地址
|
沈阳工业大学材料科学与工程学院, 沈阳, 110870
|
|
语种
|
中文 |
|
文献类型
|
研究性论文 |
|
ISSN
|
0412-1961 |
|
学科
|
金属学与金属工艺 |
|
基金
|
辽宁省沈阳市科技计划项目
|
|
文献收藏号
|
CSCD:6229045
|
参考文献 共
27
共2页
|
|
1.
Mordike B L. Magnesium: Properties-applicationspotential.
Mater. Sci. Eng., A,2001,302:37
|
CSCD被引
1217
次
|
|
|
|
|
2.
Aghion E. Magnesium alloys development towards the 21st century.
Mater. Sci. Forum,2000,350/351:19
|
CSCD被引
196
次
|
|
|
|
|
3.
Van Fleteren R. Magnesium for automotive applications.
Adv. Mater. Process,1996,149(5):33
|
CSCD被引
1
次
|
|
|
|
|
4.
Kleiner S. Mechanical anisotropy of extruded Mg-6%Al-1% Zn alloy.
Mater. Sci. Eng., A,2004,379:258
|
CSCD被引
41
次
|
|
|
|
|
5.
Bohlen J. The texture and anisotropy of magnesium-zinc-rare earth alloy sheets.
Acta Mater,2007,55:2101
|
CSCD被引
104
次
|
|
|
|
|
6.
Yin S M. Influence of Grain Size and Texture on the Yield Asymmetry of Mg-3Al-1Zn Alloy.
J. Mater. Sci. Technol,2011,27:29
|
CSCD被引
32
次
|
|
|
|
|
7.
Ball E A. Tensile-compressive yield asymmetries in high strength wrought magnesium alloys.
Scr. Metall. Mater,1994,31:111
|
CSCD被引
58
次
|
|
|
|
|
8.
Yin D L. On tension-compression yield asymmetry in an extruded Mg-3Al-1Zn alloy.
J. Alloys Compd,2009,478:789
|
CSCD被引
31
次
|
|
|
|
|
9.
毛萍莉. 高应变速率下AZ31B镁合金的压缩变形组织.
中国有色金属学报,2009,19:816
|
CSCD被引
21
次
|
|
|
|
|
10.
Watanabe H. Effect of texture on high temperature deformation behavior at high strain rates in a Mg-3Al-1Zn alloy.
Mater. Sci. Eng., A,2009,523:304
|
CSCD被引
17
次
|
|
|
|
|
11.
Agnew S R. Plastic anisotropy and the role of nonbasal slip in magnesium alloy AZ31B.
Int. J. Plast,2005,21:1161
|
CSCD被引
179
次
|
|
|
|
|
12.
Nave M D. Microstructures and textures of pure magnesium deformed in plane-strain compression.
Scr. Mater,2004,51:881
|
CSCD被引
58
次
|
|
|
|
|
13.
Yang Y B. Plastic deformation mechanisms of AZ31 magnesium alloy under high strain rate compression.
Trans. Nonferrous Met. Soc. China,2008,18:1043
|
CSCD被引
17
次
|
|
|
|
|
14.
Barnett M R. Influence of grain size on the compressive deformation of wrought Mg-3Al-1Zn.
Acta Mater,2004,52:5093
|
CSCD被引
138
次
|
|
|
|
|
15.
Barnett M R. Twinning and the ductility of magnesium alloys: Part II. "Contraction" twins.
Mater. Sci. Eng., A,2007,464:8
|
CSCD被引
257
次
|
|
|
|
|
16.
Wan G. Anisotropy of dynamic behavior of extruded AZ31 magnesium alloy.
Mater. Sci. Eng., A,2010,527:2915
|
CSCD被引
20
次
|
|
|
|
|
17.
刘正.
镁基轻质合金理论基础及其应用,2002:32
|
CSCD被引
4
次
|
|
|
|
|
18.
Barnett M R. Twinning and the ductility of magnesium alloys: Part I: "Tension" twins.
Mater. Sci. Eng., A,2007,464:1
|
CSCD被引
257
次
|
|
|
|
|
19.
Jiang L. Twinning and texture devel-opment in two Mg alloys subjected to loading along three different strain paths.
Acta Mater,2007,55:3899
|
CSCD被引
71
次
|
|
|
|
|
20.
Jiang L. Influence of {101-2} extension twinning on the flow behavior of AZ31 Mg alloy.
Mater. Sci. Eng., A,2007,445/446:302
|
CSCD被引
52
次
|
|
|
|
|
了解气象卫星更多信息，请访问