等离子喷涂纳米WC-12% Co涂层与陶瓷和不锈钢配副时的摩擦磨损性能对比研究
Comparative Study of the Friction and Wear Behavior and Wear Mechanism of Plasma Sprayed WC-12% Co Coatings Matched with Ceramic and Stainless Steel Balls under Dry Sliding Condition
查看参考文献8篇
|
文摘
|
利用大气等离子喷涂技术制备了纳米和微米WC-12% Co涂层,采用SRV摩擦磨损试验机考察了纳米和微米WC-12%Co涂层在干摩擦条件下分别与Si_3N_4陶瓷球和不锈钢球配副时的摩擦磨损性能.结果表明:在相同试验条件下,纳米和微米WC-12% Co涂层分别与Si_3N_4陶瓷球和不锈钢球配副时的摩擦系数相差不大,但纳米WC-12% Co涂层的抗磨性能明显优于微米WC-12% Co涂层;2种涂层的磨损机制差异亦较小,纳米涂层在低载荷下的主要磨损机制为微断裂和轻微磨粒磨损,而在较高载荷下的磨损机制为硬质相的剥落和磨粒磨损;微米涂层在较低载荷下的磨损机制为微断裂和磨粒磨损,在较高载荷下为疲劳磨损.在相同试验条件下,纳米WC-12% Co涂层的磨损表面损伤明显较轻微. |
|
其他语种文摘
|
Nanostructured and conventional WC-12%Co coatings were deposited on stainless steel substrate using atmospheric plasma spraying. The friction and wear properties of the coatings sliding against silicon nitride ceramic ball and stainless steel ball under dry condition were investigated using an SRV friction and wear tester. As slid against the ceramic and stainless steel counterparts under the same conditions, the results show that the two types of plasma sprayed WC-12%Co coatings exhibited minor differences in friction coefficients and wear mechanism. Both nanostructured and microstructured coatings were dominated by slight micro-cracking and abrasive wear at relatively lower load, while they were characterized by severe abrasive wear and brittle fracture at relatively larger load. However, the nanostructured coating experienced less worn surface damage and showed much better wear resistance than the conventional one under the same testing condition. This could be largely attributed to the more compact microstructure and higher microhardness, cohesion, and adhesion to substrate of the nanostructured WC-12%Co coating as compared with the conventional coating. |
|
来源
|
摩擦学学报（中英文）
,2008,28(3):213-218 【核心库】
|
|
关键词
|
等离子喷涂
;
WC-12% Co涂层
;
摩擦磨损性能
|
|
地址
|
中国科学院兰州化学物理研究所, 固体润滑国家重点实验室, 甘肃, 兰州, 730000
|
|
语种
|
中文 |
|
文献类型
|
研究性论文 |
|
ISSN
|
1004-0595 |
|
学科
|
机械、仪表工业 |
|
基金
|
国家自然科学基金创新研究群体项目
;
国家973计划
|
|
文献收藏号
|
CSCD:3300006
|
参考文献 共
8
共1页
|
|
1.
徐滨士. 纳米表面工程.
中国机械工程,2000,11(6):707-712
|
CSCD被引
38
次
|
|
|
|
|
2.
Zhu Y C. Tribological properties of nanostructured and conventional WC-Co coatings deposited. by plasma spraying.
Thin Solid Films,2001,388(1/2):277-282
|
CSCD被引
33
次
|
|
|
|
|
3.
Lin X H. Thermal diffusivity of plasma sprayed monolithic coating of alumina-3 wt. %titania produced with nanostructured powder.
Surface and Coatings Technology,2005,195(1):85-90
|
CSCD被引
2
次
|
|
|
|
|
4.
关耀辉. 等离子喷涂纳米FeS涂层的摩擦磨损性能研究.
摩擦学学报,2006,26(4):320-324
|
CSCD被引
12
次
|
|
|
|
|
5.
Zhu Y C. Deposition and characterization of nanostructured WC-Co coating.
Ceramics International,2001,27(6):669-674
|
CSCD被引
14
次
|
|
|
|
|
6.
Zhou H. Nanostructured yttria stabilized zirconia coatings deposited by air plasma spraying.
Transactions of Nonferrous Metals Society of China,2007,17(2):389-393
|
CSCD被引
15
次
|
|
|
|
|
7.
Stewart D A. Microstructural evolution in thermally sprayed WC-Co coatings:comparison between nanocomposite and conventional starting powders.
Acta Materialia,2000,48(7):1593-1604
|
CSCD被引
43
次
|
|
|
|
|
8.
Zhao X Q. Comparative study of the friction and wear behavior of plasma sprayed conventional and nanostructured WC-12%Co coatings on stainless steel.
Materials Science and Engineering A,2006,431(2):290-297
|
CSCD被引
11
次
|
|
|
|
|
了解气象卫星更多信息，请访问