CNTs/Mg-9Al复合材料微观组织、力学及导热性能
Microstructure,mechanical and thermal properties of CNTs/Mg-9Al composites
查看参考文献28篇
|
文摘
|
研究了CNTs的加入对Mg-9Al镁基复合材料时效行为的影响,探讨了时效处理过程中微观组织、力学性能及导热性能的演变规律。结果表明:添加的CNTs增大了基体合金中铝元素的固溶度,并在时效过程中限制晶界的迁移,在二者共同作用下,促进基体中连续β-Mg_(17)Al_(12)相的析出,且随着CNTs含量的增加,连续析出的比例增大;与基体呈共格关系的杆状连续析出相能够有效地阻碍位错运动,提高复合材料的力学性能,其中峰时效态0.4CNTs/Mg-9Al复合材料的屈服强度、抗拉强度、热扩散系数和热导率分别为275MPa,369MPa,34.5mm~2/s和68.4W/(m·K),相较于时效前Mg-9Al合金分别提升了17%,23%,43%和45%。 |
|
其他语种文摘
|
The effect of carbon nanotubes(CNTs)on the aging behavior of Mg-9Al matrix composites was studied,and the evolution of microstructures,mechanical properties and thermal conductivity of composites during the aging treatment were discussed.Results show that the addition of CNTs increases the solid solubility of Al in Mg matrix and limited the migration of grain boundaries during the aging process,which can promote the formation of continuous precipitated phasesβ-Mg_(17)Al_(12)in CNTs/Mg-9Al composites.The rod-shaped continuous precipitates in coherent relationship with Mg matrix can effectively hinder the dislocation movement,which can improve the mechanical properties of the composites.Besides,the reduction of solid solution Al atoms during aging process and the addition of CNTs can improve the thermal conductivity of the composites.The property evaluation indicates that the tensile yield strength,ultimate tensile strength,diffusivity and thermal conductivity of peak-aged 0.4CNTs/Mg-9Al composite are 275MPa,369MPa,34.5mm~2/s and 68.4 W/(m·K) respectively,showing 17%,23%,43% and 45%increasing in comparison with those of Mg-9Al before aging. |
|
来源
|
材料工程
,2023,51(1):26-35 【核心库】
|
|
DOI
|
10.11868/j.issn.1001-4381.2021.000960
|
|
关键词
|
碳纳米管
;
镁基复合材料
;
时效处理
;
力学性能
;
热导率
|
|
地址
|
1.
北京工业大学材料与制造学部, 北京, 100124
2.
中国电子科技集团公司第三十八研究所, 合肥, 230088
|
|
语种
|
中文 |
|
文献类型
|
研究性论文 |
|
ISSN
|
1001-4381 |
|
学科
|
一般工业技术 |
|
基金
|
国家重点研发项目
|
|
文献收藏号
|
CSCD:7390470
|
参考文献 共
28
共2页
|
|
1.
刘正.
镁基轻质合金理论基础及其应用,2002:2-5
|
被引
1
次
|
|
|
|
|
2.
陈振华.
变形镁合金,2005:1
|
被引
46
次
|
|
|
|
|
3.
Ren Y. Tension-tension fatigue behavior of unidirectional single-walled carbon nanotube reinforced epoxy composite.
Carbon,2003,41(11):2177-2179
|
被引
5
次
|
|
|
|
|
4.
Ma P C. Dispersion and functionalization of carbon nanotubes for polymer-based nanocomposites: a review.
Composites:Part A,2010,41(10):1345-1367
|
被引
53
次
|
|
|
|
|
5.
Volkov A Y. Improving the mechanical properties of pure magnesium through cold hydrostatic extrusion and low-temperature annealing.
Materials Science and Engineering: A,2015,627:56-60
|
被引
7
次
|
|
|
|
|
6.
Shi H L. A Novel Melt Processing for Mg Matrix Composites Reinforced by Multiwalled Carbon Nanotubes.
Journal of Materials Science and Technology,2016,32:1303-1308
|
被引
6
次
|
|
|
|
|
7.
Chen M L. Design of an efficient flake powder metallurgy route to fabricate CNT/6061Al composites.
Materials & Design,2018,142:288-296
|
被引
5
次
|
|
|
|
|
8.
Li H P. Microstructure and properties of carbon nanotubes-reinforced magnesium matrix composites fabricated vianovel in situ synthesis process.
Journal of Alloys and Compounds,2019,785:146-155
|
被引
1
次
|
|
|
|
|
9.
张军. 粉末冶金法制备CNT和SiC混杂增强铝基复合材料的摩擦磨损性能.
材料工程,2020,48(11):131-139
|
被引
1
次
|
|
|
|
|
10.
Mishra M. Microstructural and mechanical studies of multi-walled CNTs/Mg composite fabricated through FSP.
Journal of Composite Materials,2021,55(22)
|
被引
1
次
|
|
|
|
|
11.
Goh C S. Simultaneous enhancement in strength and ductility by reinforcing magnesium with carbon nanotubes.
Materials Science and Engineering A,2006,423:153-156
|
被引
19
次
|
|
|
|
|
12.
Han G Q. Synthesis of CNT-reinforced AZ31magnesium alloy composites with uniformly distributed CNTs.
Materials Science and Engineering A,2015,628:350-357
|
被引
4
次
|
|
|
|
|
13.
覃嘉宇. 碳纳米管(CNTs)增强AZ91镁基复合材料组织与力学性能研究.
金属学报,2019,55(12):1537-1543
|
被引
3
次
|
|
|
|
|
14.
Paramsothy M. Carbon nanotube addition to concentrated magnesium alloy AZ81:enhanced ductility with occasional significant increase in strength.
Materials & Design,2013,45(6):15-23
|
被引
9
次
|
|
|
|
|
15.
Hou J T. Combination of enhanced thermal conductivity and strength of MWCNTs reinforced Mg-6Zn Matrix Composite.
Journal of Alloys and Compounds,2020,838:155573
|
被引
4
次
|
|
|
|
|
16.
杜文博. 碳纳米管增强镁基复合材料导热性能研究.
中国材料进展,2020,39(1):12-18
|
被引
3
次
|
|
|
|
|
17.
Li B C. Microstructure and thermal conductivity of Mg-2Zn-Zr alloy.
Journal of Alloys Compounds,2017,722:772-777
|
被引
6
次
|
|
|
|
|
18.
Wang C M. Effect of precipitates on thermal conductivity of aged Mg-5Sn alloy.
Philosophical Magazine,2017,97(20):1698-1707
|
被引
2
次
|
|
|
|
|
19.
杨心语.
Mg-xGd-1Er-yZn-0.6Zr合金导热及力学性能研究,2020
|
被引
1
次
|
|
|
|
|
20.
Duly D. On the competition between continuous and discontinuous precipitation in binary Mg-Al alloys.
Acta Metallurgica et Materialia,1995,43(1):101-106
|
被引
56
次
|
|
|
|
|
了解气象卫星更多信息，请访问