基于LED纳秒级脉冲的SiPM阵列监测电路
SiPM Array Monitoring Circuit Based on LED Nanosecond Pulse
查看参考文献16篇
文摘
|
环形正负电子对撞机(CEPC)电磁量能器(ECAL)原型机的探测单元采用硅光电倍增管(SiPM)作为光电转换器件。由于SiPM具有温度依赖性强和响应速度快的特点,需监测电路产生与SiPM响应速度相匹配的脉冲光激发SiPM,对其增益和动态范围进行监测。本文根据模拟仿真结果,设计了基于双NMOS的驱动电路和相应的控制电路,该电路驱动发光二极管(LED)发射纳秒级窄脉冲光,且强度可调。利用光电倍增管(PMT)测得单路LED发光时域特性,脉冲时间宽度约为10ns。在CEPC ECAL电子学联测中,SiPM监测电路正常工作,批量测得ECAL原型机中SiPM的增益指标,满足原型机的自检需求。 |
其他语种文摘
|
In the prototype of the electromagnetic calorimeter(ECAL)of the circular electron positron collider(CEPC),a silicon photomultiplier(SiPM)is used to convert light to electronic signal as part of detector cell.Due to the strong temperature dependence and fast response speed of SiPM,a monitoring circuit is required to monitor its gain and dynamic range by generating pulse light which matches the response speed of SiPM to excite SiPM.In this paper,based on the simulation result,a dual NMOS-based driving circuit and corresponding control circuit were designed.The circuit drives a light emitting diode(LED)to emit nanosecond-level narrow pulse light with adjustable intensity. The photomultiplier(PMT)was used to measure the time-domain characteristics of single LED light emission,and the time width of light pulse is about 10ns.In the joint test with the electronics of CEPC ECAL,the SiPM monitoring circuit works as expected,and the gain of SiPMs in the ECAL prototype is successfully measured in batches, which meets the self-test requirement of the prototype. |
来源
|
原子能科学技术
,2020,54(6):1047-1054 【核心库】
|
DOI
|
10.7538/yzk.2020.youxian.0046
|
关键词
|
发光二极管
;
脉冲驱动
;
硅光电倍增器
;
增益监测
|
地址
|
1.
中国科学技术大学, 核探测与核电子学国家重点实验室, 安徽, 合肥, 230026
2.
中国科学技术大学近代物理系, 安徽, 合肥, 230026
|
语种
|
中文 |
文献类型
|
研究性论文 |
ISSN
|
1000-6931 |
学科
|
物理学 |
基金
|
国家自然科学基金资助项目
;
国家重点研发计划资助项目
|
文献收藏号
|
CSCD:6739711
|
参考文献 共
16
共1页
|
1.
The CEPC-SPPC Study Group.
CEPC conceptual design report
|
被引
1
次
|
|
|
|
2.
Yang H. Preliminary conceptual design about the CEPC calorimeters.
International Journal of Modern Physics A,2016,31(33):1644026
|
被引
1
次
|
|
|
|
3.
Thomson M A. Particle flow calorimetry and the PandoraPFA algorithm.
Nuclear Instruments and Methods in Physics Research A,2009,611(1):25-40
|
被引
3
次
|
|
|
|
4.
Sirunyan A M. Particle-flow reconstruction and global event description with the CMS detector.
JINST,2017,12(10):10003
|
被引
1
次
|
|
|
|
5.
Atlas Collaboration. Jet reconstruction and performance using particle flow with the ATLAS detector.
The European Physical Journal C,2017,77(7):466
|
被引
1
次
|
|
|
|
6.
Buzhan P. Silicon photomultiplier and its possible applications.
Nuclear Instruments and Methods in Physics Research A,2003,504(1/3):48-52
|
被引
15
次
|
|
|
|
7.
Roncali E. Application of silicon photomultipliers to positron emission tomography.
Annal of Biomedical Engineering,2011,39(4):1358-1377
|
被引
6
次
|
|
|
|
8.
Marco R. Characterization of SiPM:Temperature dependencies.
2008IEEE Nuclear Science Symposium Conference Record,2008
|
被引
1
次
|
|
|
|
9.
Kvasnicka J. LED calibration systems for CALICE hadron calorimeter.
Physics Procedia,2012,37:402-409
|
被引
2
次
|
|
|
|
10.
Polak I. Fast calibration UV LED system for CALICE scintillator based tile hadron calorimeter.
IEEE Nuclear Science Symposium and Medical Imaging Conference Record,2012:1240-1243
|
被引
1
次
|
|
|
|
11.
Zhao H. Performance study for the CEPC ScW Ecal.
Proceedings of International Conference on Technology and Instrumentation in Particle Physics 2017,2017
|
被引
1
次
|
|
|
|
12.
Zhao H. Particle flow oriented electromagnetic calorimeter optimization for the circular electron positron collider.
JINST,2018,13(3):03010
|
被引
1
次
|
|
|
|
13.
Zhao S. The readout electronics research design and development for CEPC scintillators electromagnetic calorimeter prototype.
IEEE Transactions on Nuclear Science,2019,66(7):1107-1114
|
被引
1
次
|
|
|
|
14.
.
Hamamatsu S12571-015P Datasheet
|
被引
1
次
|
|
|
|
15.
.
BC400BC404 BC408 BC412 BC416 DataSheet
|
被引
1
次
|
|
|
|
16.
Gruber L. Over saturation behavior of SiPMs at high photon exposure.
Nuclear Instruments and Methods in Physics Research A,2014,737:11-18
|
被引
6
次
|
|
|
|
|