织构对AZ31镁合金温热压缩变形机制影响
Effect of texture on deformation mechanism of AZ31 Magnesium alloy warm compression
查看参考文献33篇
|
文摘
|
在AZ31轧制板材上截取4种具有不同晶粒取向特征的试样,在170℃温热条件下,分别对上述试样进行压缩变形,分析了变形过程中力学性能变化、晶粒取向演化和织构变化,并基于压缩过程施密特因子的分布特征,对上述变形过程中各种微观变形模式的启动趋势进行了分析,最后对上述变形过程的微观启动模式进行了定量计算.分析结果表明:织构明显影响镁合金压缩变形过程的微观变形机制,从而对宏观力学性能产生明显影响,平行于晶粒c轴压缩因大量的柱面滑移系启动而呈现最高应力值.随着晶粒c轴与压缩方向夹角的增大,拉伸孪晶启动量增加而导致织构明显改变. |
|
其他语种文摘
|
Four kinds of samples with different grain orientation were machined from the rolled AZ31 Mg alloy sheet, and they were compressed at warm temperature of 170 ℃, the mechanical property, grain orientation and texture evolution, micro deformation mode activation tendency were analyzed based on the Schmid factor distribution of compression, and quantitative analysis on the micro deformation modes of above deformations was carried out. The analysis results show that texture evidently affects micro deformation mechanism of Mg alloy compression, subsequently obviously affects the macro mechanical property. The compression along the c axis of grains displays the highest stress due to amounts of prismatic slips activation. The texture is obviously changed due to more extension twins activation with the angle between the compression direction and c axis of grains increased. |
|
来源
|
中国有色金属学报
,2018,28(11):2206-2216 【核心库】
|
|
DOI
|
10.19476/j.ysxb.1004.0609.2018.11.05
|
|
关键词
|
织构
;
AZ31镁合金
;
温热压缩
;
滑移
;
孪晶
|
|
地址
|
1.
沈阳航空航天大学材料科学与工程学院, 沈阳, 110036
2.
中国科学院金属研究所, 沈阳, 110016
|
|
语种
|
中文 |
|
文献类型
|
研究性论文 |
|
ISSN
|
1004-0609 |
|
学科
|
金属学与金属工艺 |
|
基金
|
国家自然科学基金资助项目
|
|
文献收藏号
|
CSCD:6453082
|
参考文献 共
33
共2页
|
|
1.
秦博. AZ31镁合金温热变形本构方程.
沈阳理工大学学报,2016,35(3):91-95
|
被引
1
次
|
|
|
|
|
2.
Wang Xinwei. Modeling of thermal and mechanical behavior of a magnesium alloy AZ31 during electrically-assisted micro-tension.
International Journal of Plasticity,2016,85:230-257
|
被引
8
次
|
|
|
|
|
3.
Huang Guangsheng. Effects of grain size on shift of neutral layer of AZ31 magnesium alloy under warm condition.
Transactions of Nonferrous Metals Society of China,2015,25(3):732-737
|
被引
5
次
|
|
|
|
|
4.
Gao Tiejun. Viscous warm pressure bulging process of AZ31B magnesium alloy with different ellipticity dies.
Transactions of Nonferrous Metals Society of China,2017,27(1):157-162
|
被引
4
次
|
|
|
|
|
5.
张士宏. 镁合金板件温热成形技术的几个新进展.
材料导报,2006,20(8):114-118
|
被引
9
次
|
|
|
|
|
6.
张佩武. 变形镁合金成形工艺研究及其应用.
材料导报,2005,19(7):82-85
|
被引
13
次
|
|
|
|
|
7.
高仑. 镁合金成型技术的开发与应用.
轻合金加工技术,2004,32(3):5-12
|
被引
15
次
|
|
|
|
|
8.
Jiang J. Microtexture evolution via deformation twinning and slip during compression of magnesium alloy AZ31.
Materials Science and Engineering A,2008,483/484:576-579
|
被引
20
次
|
|
|
|
|
9.
Pei Y. Effect of crystal orientation on the deformation behavior of the magnesium alloy AZ31 during plane strain compression.
Journal of Chinese Electron Microscopy Society,2009,28(1):6-10
|
被引
2
次
|
|
|
|
|
10.
吴新星. 初始取向对AZ31镁合金微观织构演化的影响.
金属学报,2011,47(2):140-144
|
被引
8
次
|
|
|
|
|
11.
董勇. 初始取向对大应变轧制AZ31镁合金板材显微组织和力学性能的影响.
中国有色金属学报,2014,24(7):1700-1706
|
被引
5
次
|
|
|
|
|
12.
Wang B S. Effect of crystal orientation on the mechanical properties and strain hardening behavior of magnesium alloy AZ31 during uniaxial compression.
Materials Science and Engineering A,2012,534:588-593
|
被引
10
次
|
|
|
|
|
13.
Zambaldi C. Orientation dependent deformation by slip and twinning in magnesium during single crystal indentation.
Acta Materialia,2015,91:267-288
|
被引
3
次
|
|
|
|
|
14.
Xiong Y. Deformation of extruded ZK60 magnesium alloy under uniaxial loading in different material orientations.
Materials Science & Engineering A,2018,710:206-213
|
被引
4
次
|
|
|
|
|
15.
张士宏. 镁合金板材温热变形机理及温热成形技术.
机械工程学报,2012,48(18):28-34
|
被引
18
次
|
|
|
|
|
16.
Jain A. Modeling the temperature dependent effect of twinning on the behavior of magnesium alloy AZ31B sheet.
Materials Science and Engineering A,2007,462:29-36
|
被引
36
次
|
|
|
|
|
17.
詹美燕. 镁合金的塑性变形机制和孪生变形研究.
材料导报,2011,5(2):1-7
|
被引
21
次
|
|
|
|
|
18.
Godet S. Use of Schmid factors to select extension twin variants in extruded magnesium alloy tubes.
Scripta Materialia,2006,55:1055-1058
|
被引
20
次
|
|
|
|
|
19.
Scott J. Room temperature shear band development in highly twinned wrought magnesium AZ31B sheet.
Metallurgical and Materials Transactions A,2013,44:512-516
|
被引
1
次
|
|
|
|
|
20.
Chun Y B. Texture effects on development of shear bands in rolled AZ31 alloy.
Materials Science & Engineering A,2012,556:253-259
|
被引
5
次
|
|
|
|
|
了解气象卫星更多信息，请访问