高超声速溢流冷却实验研究
EXPERIMENTAL STUDY OF HYPERSONIC OVERFLOW COOLING
查看参考文献23篇
|
文摘
|
高超声速溢流冷却是一种新型的飞行器热防护方法,基本思想为:在高热流区布置溢流孔,控制冷却液以溢流方式流出,之后通过飞行器表面摩阻作用展布为液膜,形成热缓冲层以降低飞行器表面热流.目前,溢流冷却技术还处于探索阶段,实现工程应用前还需开展大量的实验验证和机理研究工作.本文首次开展溢流冷却的实验研究工作,采用热流测量、液膜厚度测量及液膜流动特性观测技术,搭建了完善的溢流冷却风洞实验平台,对溢流冷却热防护性能和高超声速条件下液膜流动规律进行了初步研究.研究表明:(1)高超声速流场中通过溢流能够在飞行器表面形成液膜并有效隔离外部高温气流,可降低飞行器表面热流率;(2)楔面上的液膜前缘流动是一个逐渐减速的过程,增加冷却液流量液膜厚度变化不明显,但液膜前缘运动速度增大;(3)液膜层存在表面波,在时间和空间方向发生演化,导致液膜厚度的微弱扰动;(4)液膜层存在横向展宽现象,即液膜层宽度大于溢流缝宽度.原因是液膜层与流场边界层条件不匹配,存在压力梯度,迫使冷却液向低压区流动,从而展宽液膜层,并且流量越高,横向展宽现象越明显. |
|
其他语种文摘
|
Hypersonic overflow cooling is a new type of aircraft thermal protection method. The basic idea is that the overflow hole is arranged in the high heat flux area, and the coolant poured out in an overflow way.The liquid film spreads through the aircraft surface friction forming a thermal buffer layer to reduce the surface heat flux. Now, the overflow cooling technology is still in the exploratory stage, and a large number of experimental verification and mechanism research work need to do. In this paper, wind tunnel experiment platform for overflow cooling was build, adopting the heat flux measurement, liquid film thickness measurement and liquid film motion observation technology. The feasibility of applying overflow cooling to hypersonic thermal protection was verified, and the characteristics of liquid film flow under hypersonic flow field were preliminary analyzed. Reserch results show that: (1) In hypersonic flow field, the liquid film can be formed on the vehicle surface, and effectively isolate the external high temperature air to reduce the surface heat flux; (2) On wedge surface, the leading velocity of the liquid film gradually decelerate. Increase coolant flow rate, the liquid film thickness change is not obvious, but the leading velocity of liquid film will increase; (3) Surface waves exist in liquid film, and evolve in time and space direction, which leads to slight perturbation of liquid film thickness; (4) There is a lateral expansion phenomenon in the liquid film layer, that is, the width of the liquid film is greater than that of the overflow hole. The reason is that the liquid film layer don't match the flow field boundary condition, and there is pressure gradient, forcing the coolant to flow to low pressure area, thus broadening the liquid film layer. |
|
来源
|
力学学报
,2018,50(1):1-8 【核心库】
|
|
DOI
|
10.6052/0459-1879-17-289
|
|
关键词
|
高超声速热防护
;
主动冷却
;
溢流冷却
;
液膜
|
|
地址
|
1.
中国科学院力学研究所, 高温气体动力学国家重点实验室, 北京, 100190
2.
中国科学院大学工程科学学院, 北京, 100049
|
|
语种
|
中文 |
|
文献类型
|
研究性论文 |
|
ISSN
|
0459-1879 |
|
学科
|
航空 |
|
基金
|
国家自然科学基金资助项目
|
|
文献收藏号
|
CSCD:6175958
|
参考文献 共
23
共2页
|
|
1.
刘成. 转捩位置对全动舵面热气动弹性的影响.
力学学报,2017,49(4):802-810
|
被引
8
次
|
|
|
|
|
2.
Glass D E. Ceramicmatrixcomposite(CMC)thermalprotectionsystems (TPS) and hot structures for hypersonic vehicles.
15th AIAA Space Planes and Hypersonic Systems and Technologies Conference. 28,2008:1-36
|
被引
2
次
|
|
|
|
|
3.
Shen L. An experimental investigation on transpiration cooling with phase change under supersonic condition.
Applied Thermal Engineering,2016,105:549-556
|
被引
9
次
|
|
|
|
|
4.
Wang J H. An experimental investigation on transpiration cooling of wedge shaped nose cone with liquid coolant.
International Journal of Heat and Mass Transfer,2014,75:442-449
|
被引
10
次
|
|
|
|
|
5.
Huang G. Experimental investigation of transpiration cooling with phase change for sintered porous plates.
International Journal of Heat and Mass Transfer,2017,114:1201-1213
|
被引
9
次
|
|
|
|
|
6.
Barzegar Gerdroodbary M. Investigation of film cooling on nose cone by a forward facing array of micro-jets in Hypersonic flow.
International Communications in Heat and Mass Transfer,2015,64:42-49
|
被引
12
次
|
|
|
|
|
7.
Sriram R. Film cooling at hypersonic Mach numbers using forward facing array of micro-jets.
International Journal of Heat and Mass Transfer,2009,52(15):3654-3664
|
被引
11
次
|
|
|
|
|
8.
Wang Z G. Experimental investigation on drag and heat flux reduction in supersonic/hypersonic flows: A survey.
Acta Astronautica,2016,129:95-110
|
被引
10
次
|
|
|
|
|
9.
侯宜朋. 对流式主动冷却结构影响参数分析.
固体火箭技术,2016,39(1):90-94
|
被引
5
次
|
|
|
|
|
10.
孙健. 翼前缘层板对流冷却结构的防热效果分析.
物理学报,2012,61(12):379-386
|
被引
3
次
|
|
|
|
|
11.
Anthony F.
Data and results from a study of internal convective cooling systems for hypersonic aircraft. NASA CR-132432,1974
|
被引
1
次
|
|
|
|
|
12.
Aso S. A study on aerodynamic heating reduction due to opposing jet in hypersonic flow.
AIAA Paper,2002,646:2002
|
被引
1
次
|
|
|
|
|
13.
Hayashi K. Numerical study of thermal protection system by opposing jet.
43rd Aiaa Aerospace Sciences Meeting and Exhibit,2005:2005-0188
|
被引
1
次
|
|
|
|
|
14.
何琨. 逆向喷流流场模态分析及减阻特性研究.
力学学报,2006,38(4):438-445
|
被引
10
次
|
|
|
|
|
15.
Fujita M. Axisymmetric oscillations of an opposing jet from a hemispherical nose.
AIAA Journal,2015,33(33):1850-1856
|
被引
6
次
|
|
|
|
|
16.
耿云飞. 高超声速自适应激波针数值研究.
力学学报,2011,43(3):441-446
|
被引
3
次
|
|
|
|
|
17.
Ahmed M Y M. Recent advances in the aerothermodynamics of spiked hypersonic vehicles.
Progress in Aerospace Sciences,2011,47(6):425-449
|
被引
16
次
|
|
|
|
|
18.
Gauer M. Numerical investigation of a spiked blunt nose cone at hypersonic speeds.
Journal of Spacecraft & Rockets,2008,45(3):459-471
|
被引
7
次
|
|
|
|
|
19.
张江. 带喷流激波针流动特性实验研究D.
力学学报,2016,48(5):1040-1048
|
被引
2
次
|
|
|
|
|
20.
Silton S I. Use of an axial nose-tip cavity for delaying ablation onset in hypersonic flow.
Journal of Fluid Mechanics,2005,528:297-321
|
被引
9
次
|
|
|
|
|
了解气象卫星更多信息，请访问