含硅无氢非晶碳基薄膜的摩擦磨损性能
Friction and Wear Properties of Si-containing H-free Amorphous Carbon-based Films
查看参考文献19篇
|
文摘
|
为了研究Si掺杂对无氢非晶碳基薄膜摩擦磨损性能的影响,利用直流磁控溅射技术在单晶硅和304不锈钢基底上沉积不同Si含量的无氢非晶碳基薄膜。采用SEM、Raman光谱、纳米压痕仪等分析手段对薄膜的成分、结构和力学性能进行表征。利用球盘式往复摩擦试验机测试薄膜在无润滑条件下的滑动摩擦磨损性能。结果表明:Si掺杂能降低薄膜内应力和促进sp~3杂化,高于10%的Si原子导致薄膜硬度增加。在不同湿度条件下,Si掺杂并未明显影响溅射无氢非晶碳基薄膜的摩擦因数;相反,含Si薄膜在不同测试条件下都具有较高的磨损速率。薄膜磨损速率随相对湿度增加而减小,随Si含量增加而增加;高Si含量薄膜在低湿度条件下具有明显不稳定的摩擦因数和显著增加的磨损速率。这意味着在设计和发展性能优异的无氢非晶碳基摩擦学涂层时,应充分考虑Si掺杂导致的性能损失。 |
|
其他语种文摘
|
To investigate the effect of Si incorporation on friction and wear properties of H-free amorphous carbon-based films, Si-containing H-free amorphous carbon films were deposited on Si and 304 stainless steel substrates by direct current magnetron sputtering method. The composition, structure and mechanical properties of the films were examined by scanning electron microscopy (SEM), Raman spectra, nanoindenter and other techniques. The tribological properties of the films were tested in dry contact conditions using a reciprocating sliding tribometer with ball-on-disk contact geometry. The results indicate that Si incorporation reduces the residual stress of films and promotes the sp~3 hybridization. The film hardness is increased by Si incorporation over 10%. The addition of Si has little influence on friction coefficient of H-free carbon film under various wetting conditions. Si-doped films show higher wear rates than the H-free film, and their wear rates increase with increasing Si contents and decreasing relative humidity. High Si content within films causes significant instability of friction coefficient and leads to severe wear of the films in the low humid air. This suggests that the degradation in performance resulting from Si doping should be fully considered in designing and developing H-free amorphous carbon-based tribological coatings with excellent properties. |
|
来源
|
中国表面工程
,2017,30(1):93-100 【核心库】
|
|
DOI
|
10.11933/j.issn.1007–9289.20160907001
|
|
关键词
|
非晶碳基薄膜
;
硅
;
摩擦
;
磨损
|
|
地址
|
1.
中国科学院兰州化学物理研究所, 固体润滑国家重点实验室, 兰州, 730000
2.
中国科学院宁波材料技术与工程研究所, 浙江, 宁波, 315201
|
|
语种
|
中文 |
|
文献类型
|
研究性论文 |
|
ISSN
|
1007-9289 |
|
学科
|
金属学与金属工艺 |
|
基金
|
国家自然科学基金
|
|
文献收藏号
|
CSCD:5925506
|
参考文献 共
19
共1页
|
|
1.
薛群基.
类金刚石碳基薄膜材料,2012
|
被引
53
次
|
|
|
|
|
2.
Robertson J. Comparison of diamond-like carbon to diamond for applications.
Physica Status Solidi(A),2008,205(9):2233-2244
|
被引
5
次
|
|
|
|
|
3.
Bewilogua K. History of diamond-like carbon films-from first experiments to worldwide applications.
Surface & Coatings Technology,2014,242(4):214-225
|
被引
24
次
|
|
|
|
|
4.
Al Mahmud K A H. An updated overview of diamond-like carbon coating in tribology.
Critical Reviews in Solid State and Materials Sciences,2015,40(2):90-118
|
被引
12
次
|
|
|
|
|
5.
Damasceno J C. Deposition of Si-DLC films with high hardness, low stress and high deposition rates.
Surface & Coatings Technology,2000,133/134(11):247-252
|
被引
12
次
|
|
|
|
|
6.
Choi J. The effects of Si incorporation on the thermal and tribological properties of DLC films deposited by PBII&D with bipolar pulses.
Surface & Coatings Technology,2007,201(19):8357-8361
|
被引
6
次
|
|
|
|
|
7.
Wang J. Interface architecture for superthick carbon-based films toward low internal stress and ultrahigh load-bearing capacity.
ACS Applied Materials & Interfaces,2013,5(11):5015-5024
|
被引
14
次
|
|
|
|
|
8.
Kim M G. Tribological behavior of silicon-incorporated diamond-like carbon films.
Surface & Coatings Technology,1999,112(1):204-209
|
被引
2
次
|
|
|
|
|
9.
Yang S H. Effect of environment on the tribological behavior of Si-incorporated diamond-like carbon films.
Wear,2002,252(1):70-79
|
被引
4
次
|
|
|
|
|
10.
Oguri K. Tribological properties and characterization of diamond-like carbon coatings with silicon prepared by plasma-assisted chemical vapour deposition.
Surface & Coatings Technology,1991,47(1/2/3):710-721
|
被引
7
次
|
|
|
|
|
11.
Zhou S. Achieving low tribological moisture sensitivity by a-C:Si:Al carbon-based coating.
Tribology Letters,2011,43(3):329-339
|
被引
2
次
|
|
|
|
|
12.
Jantschner O. Sputtered Si-containing low-friction carbon coatings for elevated temperatures.
Tribology International,2014,77(6):15-23
|
被引
3
次
|
|
|
|
|
13.
Jantschner O. Origin of temperature-induced low friction of sputtered Si-containing amorphous carbon coatings.
Acta Materialia,2015,82:437-446
|
被引
5
次
|
|
|
|
|
14.
Kulikovsky V. Mechanical properties of hydrogen-free a-C:Si films.
Diamond and Related Materials,2004,13(4):1350-1355
|
被引
4
次
|
|
|
|
|
15.
Ong S E. Relationship between bonding structure and mechanical properties of amorphous carbon containing silicon.
Diamond and Related Materials,2007,16(8):1628-1635
|
被引
4
次
|
|
|
|
|
16.
Kim D W. Effects of sliding velocity and normal load on friction and wear characteristics of multi-layered diamond-like carbon (DLC) coating prepared by reactive sputtering.
Wear,2013,297(1):722-730
|
被引
9
次
|
|
|
|
|
17.
Konicek A R. Influence of surface passivation on the friction and wear behavior of ultrananocrystalline diamond and tetrahedral amorphous carbon thin films.
Physical Review B,2012,85(15):155448
|
被引
9
次
|
|
|
|
|
18.
Jiang J. The effect of relative humidity on wear of a diamond-like carbon coating.
Surface & Coatings Technology,2003,167(2):221-225
|
被引
3
次
|
|
|
|
|
19.
Donnet C.
Tribology of diamond-like carbon films: fundamentals and applications,2007
|
被引
4
次
|
|
|
|
|
了解气象卫星更多信息，请访问