帮助 关于我们

返回检索结果

高温短时间时效处理对Mg-3Nd-lZn合金微观组织及力学性能的影响
EFFECTS OF HIGH TEMPERATURE SHORT TIME AGEING TREATMENT ON THE MICROSTRUCTURES AND MECHANICAL PROPERTIES OF Mg-3Nd-lZn ALLOY

查看参考文献25篇

王文辉 1   吴迪 1 *   陈荣石 1   娄长胜 2  
文摘 将固溶处理后的Mg-2.7Nd-0.6Zn-0.5Zr合金在200~300 ℃之间进行不同温度及时间的高温时效处理,研究高温短时间时效处理对合金的微观组织和力学性能的影响,并利用OM,SEM和TEM对合金的微观组织进行表征.结果表明,固溶态Mg-2.7Nd-0.6Zn-0.5Zr合金经250~275 °C高温短时间时效后,其室温屈服强度和抗拉强度最高分别增加了近70%和29%,宏观组织中出现呈直线性不均匀分布的析出相.析出相的显微形貌为颗粒状,成分为Mg_(12)Nd.析出相的线性分布方向平行于Mg基体(0001)_(Mg)基面,合金的时效硬化行为与这种沿基面呈平行线分布的颗粒状析出相密切相关.在250~275 °C范围内时效20~30 min后屈服强度较高,这是由于在变形过程中颗粒状Mg12Nd的特殊分布对基面滑移及晶粒间协调变形起到很强的抑制作用.
其他语种文摘 Among the traditional cast magnesium alloys system, Mg-3Nd- lZn alloy with high strength and heat resistance, has been widely applied in aeronautics such as in engine box and wing rib of airplane. In present research, the as-cast Mg-2.7Nd-0.6Zn-0.5Zr (NZ31) alloy was solution treated and then aged at temperatures ranging from 200 °C to 300 °C. The microstructures and mechanical properties of the aged specimens especially at relatively high temperature (225-300 °C) were systematically characterized by OM, SEM and TEM. A new kind of precipitates distributed in line was clearly found in the specimens aged at high temperature (225~275 °C) for a short time (15-30 min), which corresponded to a significant enhancement of hardness and tensile strength at room temperature. The TEM results showed that the precipitates distributed in line had a composition of Mgi2Nd and a granular shape, and mainly formed along the (0001)_(Mg) basal plane. The special distribution of the granular Mg_(12)Nd precipitates was effective barriers to the basal slips and may probably restrain the intergranular coordination during tensile deformation, leading to a large strengthening effect, that is, the yield strength and ultimate tensile strength, of the NZ31 alloy aged at 250~275 °C for 20?30 min, increased by about 70% and 29% respectively, in comparison with only the solutionized one.
来源 金属学报 ,2016,52(5):567-574 【核心库】
DOI 10.11900/0412.1961.2015.00333
关键词 镁合金 ; 时效 ; 析出相 ; 力学性能
地址

1. 中国科学院金属研究所, 沈阳, 110016  

2. 沈阳理工大学材料科学与工程学院, 沈阳, 110159

语种 中文
文献类型 研究性论文
ISSN 0412-1961
学科 一般工业技术
基金 国家自然科学基金项目 ;  国家973计划
文献收藏号 CSCD:5688934

参考文献 共 25 共2页

1.  Nie J F. Acta Mater,2000,48:1691 被引 111    
2.  王小娜. NZ30K镁合金时效析出动力学与强化模型的研究. 金属学报,2014,50:355 被引 5    
3.  刘庆. 镁合金塑性变形机理研究进展. 金属学报,2010,46:1458 被引 116    
4.  唐伟. 热处理对AZ80镁合金结构及性能的影响. 金属学报,2005,41:1199 被引 40    
5.  Li D J. Mater Sci Eng, A,2009,526:150 被引 6    
6.  Liu X B. Mater Sci Eng, A,2008,497:326 被引 6    
7.  Li J H. Mater Sci Eng, A,2012,534:1 被引 3    
8.  Liu H. Acta Mater,2014,77:133 被引 9    
9.  Fu P H. Mater Sci Eng, A,2008,496:177 被引 20    
10.  Dai J. Mater Sci Eng, A,2011,529:401 被引 2    
11.  Ma L. Mater Sci Eng, A,2012,543:12 被引 10    
12.  Wu D. Mater Des,2014,58:324 被引 10    
13.  Zheng X W. Mater Sci Technol,2011,21:275 被引 1    
14.  Ning Z L. J Mater Sci,2009,44:4264 被引 6    
15.  Wang K F. Hot Working Technol,2011,40:39 被引 1    
16.  Wang W H. Mater Sci Eng, A,2016,649:214 被引 10    
17.  Nie J F. Metall Mater Trans, A,2012,43:3891 被引 144    
18.  Pike T J. J Less Common Met,1973,30:63 被引 13    
19.  Fu P H. Mater Sci Eng, A,2008,486:183 被引 45    
20.  Wang W H. Mater Sci Forum,2015,816:362 被引 2    
引证文献 1

1 车波 预时效对变形镁合金组织与力学性能的影响 材料导报,2021,35(11A):21249-21258
被引 1

显示所有1篇文献

论文科学数据集
PlumX Metrics
相关文献

 作者相关
 关键词相关
 参考文献相关

版权所有 ©2008 中国科学院文献情报中心 制作维护:中国科学院文献情报中心
地址:北京中关村北四环西路33号 邮政编码:100190 联系电话:(010)82627496 E-mail:cscd@mail.las.ac.cn 京ICP备05002861号-4 | 京公网安备11010802043238号