帮助 关于我们

返回检索结果

基于颗粒离散元法的连接键应变软化模型及其应用
PARTICLE-DEM BASED LINKED BAR STRAIN SOFTENING MODEL AND ITS APPLICATION 1)

查看参考文献21篇

文摘 基于颗粒间的有限接触假设,提出了可表述颗粒间力、力矩传递的连接键模型.为了表征连接键的塑性、损伤及断裂过程,在连接键中引入了考虑应变软化效应的Mohr--Coulomb准则及最大拉应力准则.单一连接键的单向拉伸测试及直剪测试表明了上述连接键应变软化模型的计算精度.研究了颗粒体系的宏观应变能与颗粒平均配位数的对应关系.通过计算发现,对于二维颗粒体系,当平均配位数为5时,颗粒体系的宏观应变能与相同参数下连续介质方法(如有限元等)计算获得的应变能基本一致.利用上述连接键应变软化模型对岩石的单轴压缩过程进行了模拟,计算结果表明:岩石单轴压缩的应力应变曲线经历了线性上升段、非线性上升段、非线性下降段及缓变段等4个阶段,并给出了上述4个阶段与岩石内部损伤破裂状态的内在联系.计算结果还表明,随着断裂应变的增大,岩石的破裂模式逐渐由拉剪复合型破裂向单一压剪型破裂转化;随着断裂应变的增大,峰值应力及达到峰值应力时的应变均逐渐增大,但峰值时的破裂度及终态时的破裂度将逐渐减小.
其他语种文摘 Based on finite contact assumption between particles, a linked bar model to transmit the force and moment between particles is proposed. To represent the plastic, damage and fracture process of linked bar, the Mohr-Coulomb model and maximal tensile stress model considering strain softening effect is introduced. The numerical results of uniaxial extension test and direct shear test with single linked bar show the accuracy of the model. The relationship between equivalent macro strain energy of particles system and the average coordination number is studied. Numerical results show that, for 2D particles system, when the average coordination number equals 5, the equivalent macro strain energy of particles system coincides well with the strain energy computed by approaches based on continuous media (i.e. FEM). The uniaxial compression process of rock is simulated based on the linked bar strain softening model. The results show that, the strain-stress curve of rock during uniaxial compression could be divided to four stages, which are linear stage, hardening stage, softening stage and sliding stage, and the relationships between four stages and damage fracture status of rock are also studied. From the results, with the increase of fracture strain, the failure mode of rock changes from tensile-shear composite fracture pattern to purely compression shear fracture pattern. With the increase of fracture strain, the peak stress and corresponding critical strain increases gradually, however, the fracture degree at peak point and at final state decreases gradually.
来源 力学学报 ,2016,48(1):76-85 【核心库】
DOI 10.6052/0459-1879-15-288
关键词 颗粒流 ; 连接键 ; 应变软化 ; 单轴压缩 ; 损伤断裂
地址

中国科学院力学研究所, 中国科学院流固耦合系统力学重点实验室, 北京, 100190

语种 中文
文献类型 研究性论文
ISSN 0459-1879
学科 力学
基金 国家科技支撑计划项目 ;  国家自然科学基金青年基金
文献收藏号 CSCD:5642513

参考文献 共 21 共2页

1.  徐泳. 颗粒离散元法研究进展. 力学进展,2003,33(2):251-260 被引 120    
2.  谭青. 盾构切刀作用下岩石动态响应机制的数值模拟研究. 岩土工程学报,2013,35(2):235-242 被引 12    
3.  石崇. 地震作用下陡岩崩塌颗粒离散元数值模拟研究. 岩石力学与工程学报,2013,32(S1):2798-2805 被引 13    
4.  张社荣. 双轴压缩试验下岩石裂纹扩展的离散元分析. 岩石力学与工程学报,2013,32(S2):3083-3091 被引 16    
5.  Ji S Y. Discrete element modeling of acoustic emission in rock fracture. Theoretical and Applied Mechanics Letters,2013,3(2):021009-021009-5 被引 1    
6.  Utili S. DEM analysis of bonded granular geomaterials. International Journal for Numerical and Analytical Methods in Geomechanics,2008,32(17):1997-2031 被引 20    
7.  Onate E. A local constitutive model for the discrete element method. Application to geomaterials and concrete. Computational Particle Mechanics,2015,2:139-160 被引 1    
8.  Huang H. Discrete element modeling of tool-rock interaction I: Rock cutting. International Journal for Numerical and Analytical Methods in Geomechanics,2013,37(13):1913-1929 被引 21    
9.  Huang H. Discrete element modeling of tool-rock interaction II: rock indentation. International Journal for Numerical and Analytical Methods in Geomechanics,2013,37(13):1930-1947 被引 14    
10.  Yang B D. A study on the effects of microparameters on macroproperties for specimens created by bonded particles. Engineering Computations,2006,23(6):607-631 被引 23    
11.  Yoon J. Application of experimental design and optimization to PFC model calibration in uniaxial compression simulation. International Journal of Rock Mechanics and Mining Sciences,2007,44(6):871-889 被引 86    
12.  Coetzee C J. Calibration of discrete element parameters and the modelling of silo discharge and bucket filling. Computers and Electronics in Agriculture,2009,65(2):198-212 被引 34    
13.  Wang Y. Calibration of a discrete element model for intact rock up to its peak strength. International Journal for Numerical and Analytical Methods in Geomechanics,2010,34(5):447-469 被引 12    
14.  Itasca Consulting Group Inc. PFC3D (Particle Flow Code in 3 Dimensions), Version 4.0, User's Manual,2003 被引 2    
15.  Jing L R. Fundamentals of Discrete Element Methods for Rock Engineering: Theory and Applications,2007 被引 2    
16.  吴顺川. 基于颗粒元模拟的含软弱夹层类土质边坡变形破坏过程分析. 岩土力学,2008,29(11):2899-2904 被引 16    
17.  赵国彦. 平行黏结模型中细观参数对宏观特性影响研究. 岩石力学与工程学报,2012,31(7):1491-1498 被引 33    
18.  祁原. 可破碎颗粒体在动力载荷下的耗能特性. 力学学报,2015,47(2):252-259 被引 5    
19.  Griffiths D V. Modelling of elastic continua using a grillage of structural elements based on discrete element concepts. International Journal for Numerical Methods in Engineering,2001,50(7):1759-1775 被引 5    
20.  Chang C S. Elastic constants for granular materials modeled as first-order strain-gradient continua. International Journal of Solids and Structures,2003,40(21):5565-5582 被引 4    
引证文献 13

1 武守信 基于能量等效原理的应变局部化分析:II.有限元解法 力学学报,2017,49(4):880-893
被引 1

2 修晨曦 基于微形态模型的颗粒材料中波的频散现象研究 力学学报,2018,50(2):315-328
被引 11

显示所有13篇文献

论文科学数据集
PlumX Metrics
相关文献

 作者相关
 关键词相关
 参考文献相关

版权所有 ©2008 中国科学院文献情报中心 制作维护:中国科学院文献情报中心
地址:北京中关村北四环西路33号 邮政编码:100190 联系电话:(010)82627496 E-mail:cscd@mail.las.ac.cn 京ICP备05002861号-4 | 京公网安备11010802043238号