帮助 关于我们

返回检索结果

临界产量Dupuit公式的讨论及一种新的方法
DISCUSSION ON DUPUIT FORMULA OF BOTTOM-WATER CRITICAL RATE AND A NEW COMPUTATIONAL METHOD

查看参考文献30篇

韩国锋 1   陈方方 2   刘曰武 1   朱永峰 2   马小平 2  
文摘 临界产量的确定对底水油藏的高效开发起着重要作用.然而,临界产量Dupuit公式反映临界产量随着打开程度的降低而单调增加,存在不合理的地方.本文与一些学者的研究表明,Dupuit公式推导过程暗含的"当临界状态时水锥正好处于井底"的假设不合理,水锥不能稳定在井底位置.在不作水锥到达井底的假设,假设油井上部为径向流,井底周围为半球形流动的情况下,推导出了一种新的底水临界产量方程.算例与工程实例表明,该方法比较符合实际,能够求得临界水锥高度和对打开程度进行优化.
其他语种文摘 The determination of critical rate is a key issue of high-efficient development of bottom-water reservoirs, while in the Dupuit formula of bottom-water reservoirs' critical rate, it is unreasonable that the critical rate monotonously increase with the reduction of perforating level. In fact, checking the derivation process of Dupuit formula, there is an implied condition that the top of water cone just at the well bottom. However, it is found that it can't keep a stable water cone at well-bottom when producing with the critical rate computed by Dupuit formula. In the paper, a new computational method has been established without the assumption of water-cone top at well bottom. It assumes that it is a kind of radial flow at the upper and a kind of hemispherical flow at the lower around the well bottom. The example shows that the new method could optimize the perforating level and gain the critical water-cone height. The project case demonstrates that the method gained in this study is more correspond to reality.
来源 力学学报 ,2015,47(5):863-867 【核心库】
DOI 10.6052/0459-1879-15-043
关键词 底水油藏 ; 底水锥进 ; 临界产量 ; Dupuit公式 ; 临界水锥
地址

1. 中国科学院力学研究所, 北京, 100190  

2. 中国石油天然气股份有限公司塔里木油田分公司勘探开发研究院, 新疆, 库尔勒, 841000

语种 中文
文献类型 研究性论文
ISSN 0459-1879
学科 石油、天然气工业
文献收藏号 CSCD:5525094

参考文献 共 30 共2页

1.  Ahmadi M A. Prediction breakthrough time of water coning in the fractured reservoirs by implementing low parameter support vector machine approach. Fuel,2014,117(Part A):579-589 被引 10    
2.  Zendehboudi S. Estimation of breakthrough time for water coning in fractured systems:Experimental study and connectionist modeling. American Institute of Chemical Engineers,2014,60(5):1905-1919 被引 2    
3.  Amarfio E M. Breakthrough time correlations for coning in bottom water supported reservoirs. SPE Nigeria Annual International Conference and Exhibition, 5-7 August, 2013, Lagos, Nigeria. SPE 167511-MS 被引 1    
4.  Bahadori A. A mathematical predictive tool for determining the time to water cone breakthrough in horizontal wells. Petroleum Science and Technology,2013,31(20):2047-2055 被引 2    
5.  Moradi B. The design and preparation of a simulator for the water coning phenomenon applying in fractured reservoirs. Petroleum Science and Technology,2012,30(15):1579-1590 被引 1    
6.  Bahadori A. Prediction of critical oil rate for bottom water coning in anisotropic and homogeneous formations. Journal of Petroleum Science and Engineering,2012,82/83:125-129 被引 1    
7.  熊小伟. 一种预测底水油藏水锥动态及见水时间的新方法. 断块油气田,2014,21(2):221-223 被引 4    
8.  胡志鹏. 改进的低渗透带隔板底水油藏油井见水时间的预报式. 科学技术与工程,2014,14(3):29-31 被引 1    
9.  朱维耀. 底水气藏水平井见水时间研究. 科技导报,2014,32(8):27-31 被引 4    
10.  陈朝晖. 缝洞型底水油藏油井底水突破时间预测方法——以塔河油田4区S48井为例. 石油与天然气地质,2012,33(5):791-795 被引 3    
11.  Huang S J. Water breakthrough shape description of horizontal wells in bottom-water reservoir. Mathematical Problems in Engineering,2014:Article ID 460896 被引 1    
12.  章威. 底水油藏直井水锥形态的定量描述新方法. 天然气与石油,2014,32(3):34-37 被引 5    
13.  涂彬. 厚层底水油藏油井临界产量计算方法. 石油钻探技术,2014,42(4):107-110 被引 7    
14.  Chaperon I. Theoretical study of coning toward horizontal and vertical wells in anisotropic formations. Subcritical and critical rates, SPE 15377,1986:521-526 被引 1    
15.  Giger F M. Analytic 2-D models of water cresting before breakthrough for horizontal wells. SPE Reservoir Engineering,1989,4(4):256-231 被引 8    
16.  Joshi S D. Horizontal Wells Technology,1991 被引 1    
17.  Papatzacos P. Cone breakthrough time for horizontal wells. SPE Reservoir Engineering,1991,6(3):311-318 被引 11    
18.  范子菲. 底水驱动油藏水平井临界产量公式及其变化规律研究. 石油勘探与开发,1994,21(1):65-70 被引 14    
19.  吉兰敏. 非均质底水油藏临界产量预测. 大庆石油地质与开发,2009,28(6):119-124 被引 12    
20.  宋兆杰. 考虑非达西渗流的底水锥进临界产量计算模型. 石油学报,2012,33(1):106-111 被引 7    
引证文献 1

1 黄全华 考虑井间干扰的底水气藏临界产量计算方法 世界科技研究与发展,2016,38(4):754-757,798
被引 0 次

显示所有1篇文献

论文科学数据集
PlumX Metrics
相关文献

 作者相关
 关键词相关
 参考文献相关

ResearcherID 链接
刘曰武 C-2875-2012
版权所有 ©2008 中国科学院文献情报中心 制作维护:中国科学院文献情报中心
地址:北京中关村北四环西路33号 邮政编码:100190 联系电话:(010)82627496 E-mail:cscd@mail.las.ac.cn 京ICP备05002861号-4 | 京公网安备11010802043238号