PID 控制器的频域特性与无模型参数调节
Frequency properties of PID controller and model free tuning
查看参考文献17篇
文摘
|
为了使PID参数调整不依赖于模型参数, 而是直接基于闭环响应, 首先分析PID参数对闭环系统性能的影响, 然后以振荡最小、开环增益最大等为基本原则给出一种无模型PID参数调整方法. 该方法只需要闭环响应曲线中的振荡频率信息, 避免了模型参数辨识误差对调整结果的影响, 简化了参数调节的过程. 最后通过实验验证了所提出方法的有效性. |
其他语种文摘
|
To tune PID parameters according to closed loop response, rather than the information of model parameters,the influence of PID parameters on the closed loop performance is first analyzed. Then a model free PID parameter tuning method is proposed according to the principle of least vibration and maximal open loop gain. This method only requires the information of vibration frequency of the closed loop response curves, thus the influence of model parameter identification error on the tuning result is avoided and the tuning process is simplified. Finally, experimental results show the effectiveness of the proposed method. |
来源
|
控制与决策
,2014,29(10):1833-1838 【核心库】
|
DOI
|
10.13195/j.kzyjc.2013.0582
|
关键词
|
PID控制
;
特征频率
;
闭环响应
;
频域分析
|
地址
|
中国科学院沈阳自动化研究所, 机器人学国家重点实验室, 沈阳, 110016
|
语种
|
中文 |
文献类型
|
研究性论文 |
ISSN
|
1001-0920 |
学科
|
自动化技术、计算机技术 |
基金
|
国家863计划
|
文献收藏号
|
CSCD:5276339
|
参考文献 共
17
共1页
|
1.
Hua Wuhua. An analytical method for PID controller tuning with specified gain and phase margins for integral plus time delay processes.
ISA Transactions,2011,50:268-276
|
被引
1
次
|
|
|
|
2.
Astrom K J.
PID controllers: Theory, design and tuning,1995:151-163
|
被引
1
次
|
|
|
|
3.
Konstantinos G P. Type-III closed loop control systems - Digital PID controller design.
J of Process Control,2013,23:1401-1414
|
被引
1
次
|
|
|
|
4.
Miroslav R M. Series PID controller tuning based on the SIMC rule and signal fltering.
J of Process Control,2013
|
被引
1
次
|
|
|
|
5.
Madhuranthakam C R. Optimal tuning of PID controllers for FOPTD, SOPTD and SOPTD with lead processes.
Chemical Engineering and Processing,2008,47:251-264
|
被引
8
次
|
|
|
|
6.
Schinstock D E. Loop shaping design for tracking performance in machine axes.
ISA Transactions,2006,45:55-66
|
被引
2
次
|
|
|
|
7.
Grassi E. PID controller tuning by frequency loop-shaping.
Proc of the 35th CDC,1996:680-685
|
被引
1
次
|
|
|
|
8.
姜杉. 基于模糊PID调节的核磁兼容机器人气动控制技术.
机器人,2012,34(5):531-538
|
被引
7
次
|
|
|
|
9.
段星光. 微创血管介入手术机器人控制系统与零位定位装置设计.
机器人,2012,34(2):129-136
|
被引
7
次
|
|
|
|
10.
Astrom K J. The future of PID control.
Control Engineering Practice,2001,9:1163-1175
|
被引
54
次
|
|
|
|
11.
Shamsuzzoha M. The setpoint overshoot method: A simple and fast closed-loop approach for PID tuning.
J of Process Control,2010,20:1220-1234
|
被引
8
次
|
|
|
|
12.
Ziegler J G. Optimum setting for automatic controllers.
Trans of ASME,1942,64:759-768
|
被引
116
次
|
|
|
|
13.
Aleksandar D M. Optimization of PID controller with higher-order noise flter.
J of Process Control,2013
|
被引
1
次
|
|
|
|
14.
Liu T. Closed-loop step response identification of integrating and unstable processes.
Chemical Engineering Science,2010,65:2884-2895
|
被引
2
次
|
|
|
|
15.
Ali A. PI/PID controller design based on IMC and percentage overshoot specification to controller setpoint change.
ISA Transactions,2009,48:10-15
|
被引
5
次
|
|
|
|
16.
Zhu Zhiqiang. The analysis and synthesis of PID controller based on closed loop response characteristics.
The 2012 IEEE Int Conf on Robotics and Biomimetics,2012:1930-1936
|
被引
1
次
|
|
|
|
17.
Zhu Zhiqiang. Model free analysis and tuning of PID controller.
Proc of the 9th Asia Control Conf,2013:1-7
|
被引
1
次
|
|
|
|
|