帮助 关于我们

返回检索结果

模拟岩石破裂过程的块体单元离散弹簧模型
A block-discrete-spring model to simulate failure process of rock

查看参考文献20篇

文摘 在变形体离散元的基础上建立块体单元离散弹簧模型,并应用于岩石破裂过程的数值模拟研究。该模型以连续介质力学理论为基础,将块体单元离散为具有明确物理意义的弹簧系统,通过对弹簧系统的能量泛函求变分获得各弹簧的刚度系数,进而可以直接利用弹簧刚度求解单元的变形和应力,提高计算效率。以重力作用下的岩质边坡计算为例,通过与传统的有限元进行对比,验证该模型弹性计算结果的正确性。在该基础上,引入Mohr-Coulomb与最大拉应力的复合破坏准则,判断单元的破坏状态及破裂方向。当单元的内部破坏面确定后,则通过块体切割的方式实现单元破坏,并建立单元边界和单元内部的双重破裂机制,实现块体由连续到非连续的破裂过程,进而显示的模拟裂纹的形成和扩展。最后,以巴西圆盘劈裂、单轴压缩破裂以及三点弯曲梁等典型算例验证该方法,结果表明该方法可以较好地模拟拉伸、压剪等应力状态下裂纹的形成和扩展,从而可模拟岩石介质由连续到非连续的破裂过程。
其他语种文摘 A block-discrete-spring model based on deformable discrete element method is established; this model would be applied to simulate the rock failure process. In this model, the theoretical basis is continuum mechanics and block element is divided into discrete spring system with specific physical meaning. The stiffness of the spring can be obtained from the energy functional. In this way, element deformation and stress would be calculated by spring stiffness directly and efficiently. In the case of rock mass slope under gravity, the elastic result achieved with this model is the same as that of traditional finite element method. (FEM). On this basis, Mohr-Coulomb criterion with a tensile cutoff which used to judge the failure state and broken direction is proposed and implemented into the block-discrete-spring model. After the internal failure face established, the element will be divided into two elements by means of cutting block; and double judgement including element boundary and element interior is adopted to realize the crack initiation and propagation, which could mitigate the effect of initial mesh. Finally, the rationality of the failure result calculated by block-discrete-spring model is approved by some cases including split test with flattened disk, uniaxial compression and three point bending. The results show that this method can well simulate the crack initiation and propagation under tensile, compressive and shear conditions, by which the rock failure process can be realized from continuum to discontinuum.
来源 岩土力学 ,2013,34(8):2355-2362 【核心库】
关键词 岩石力学 ; 离散弹簧 ; 单元破裂 ; 裂纹扩展
地址

中国科学院力学研究所, 北京, 100190

语种 中文
文献类型 研究性论文
ISSN 1000-7598
学科 建筑科学
基金 国家973计划 ;  国家自然科学基金重点项目资助
文献收藏号 CSCD:4901030

参考文献 共 20 共1页

1.  潘鹏志. 脆性岩石破裂演化过程的三维细胞自动机模拟. 岩土力学,2009,30(5):1471-1476 被引 15    
2.  梁正召. 岩石三维破裂过程的数值模拟研究. 岩石力学与工程学报,2006,25(5):931-936 被引 31    
3.  张楚汉. 论岩石、混凝土离散-接触-断裂分析. 岩石力学与工程学报,2008,27(2):217-235 被引 43    
4.  Goodman R E. A model for the mechanics of jointed rock. Journal of the Soil Mechanics and Foundations Division, ASCE,1968,94(3):637-659 被引 225    
5.  Ghaboussi J. Finite element for rock joints and interfaces. Journal of the Soil Mechanics and Foundations Division, ASCE,1973,99(10):833-848 被引 28    
6.  Belytschko T. Elastic crack growth in finite elements with minimal remeshing. International Journal for Numerical Methods in Engineering,1999,45(5):601-620 被引 359    
7.  Belytschko T. Arbitrary discontinuities in finite element. International Journal for Numerical Methods in Engineering,2001,50(4):993-1013 被引 53    
8.  田振农. 三维块体离散元可变形计算方法研究. 岩石力学与工程学报,2008,27(增刊1):2832-2840 被引 7    
9.  魏怀鹏. 基于连续介质模型的离散元方法中弹簧性质研究. 岩石力学与工程学报,2006,25(6):1159-1169 被引 10    
10.  Beyabanaki S A R. Three-dimensional discontinuous deformation analysis (3-D DDA) using a new contact resolution algorithm. Computer Geotech,2008,35(3):346-356 被引 12    
11.  焦玉勇. 用非连续变形分析方法模拟岩石裂纹扩展. 岩石力学与工程学报,2007,26(4):682-691 被引 41    
12.  Owen D R J. The modeling of multi-fracturing solids and particulate media. International Journal for Numerical Methods in Engineering,2004,60(1):317-339 被引 18    
13.  Munjiza A. The combined finite-discrete element method,2004:277-290 被引 5    
14.  常晓林. 模拟岩体失效全过程的连续-非连续变形体离散元方法及应用. 岩石力学与工程学报,2011,30(10):2004-2011 被引 26    
15.  Li Shihai. A spring system equivalent to continuum model. The Fifth International Conference on Discrete Element Methods,2010:75-85 被引 2    
16.  冯春. 基于连续介质力学的块体单元离散弹簧法研究. 岩石力学与工程学报,2010,29(增刊1):2690-2704 被引 12    
17.  Li S H. A continuum-based discrete element method for continuous deformation and failure process. WCCM VI in Conjunction with APCOM'04,2004 被引 4    
18.  张盛. 用5种圆盘试件的劈裂试验确定岩石断裂韧度. 岩土力学,2009,30(1):12-18 被引 32    
19.  杨艳霜. 大理岩单轴压缩时滞性破坏的试验研究. 岩土力学,2011,32(9):2714-2720 被引 9    
20.  Moes N. Extended finite element method for cohesive crack growth. Engineering Fracture Mechanics,2002,69(7):813-833 被引 68    
引证文献 17

1 王杰 基于单元破裂的岩石裂纹扩展模拟方法 力学学报,2015,47(1):105-118
被引 18

2 冯春 一种有限元转化为颗粒离散元的方法及其应用研究 岩土力学,2015,36(4):1027-1034
被引 1

显示所有17篇文献

论文科学数据集
PlumX Metrics
相关文献

 作者相关
 关键词相关
 参考文献相关

版权所有 ©2008 中国科学院文献情报中心 制作维护:中国科学院文献情报中心
地址:北京中关村北四环西路33号 邮政编码:100190 联系电话:(010)82627496 E-mail:cscd@mail.las.ac.cn 京ICP备05002861号-4 | 京公网安备11010802043238号