帮助 关于我们

返回检索结果

镍基合金DD10中γ/γ'晶格错配度厚度效应的X射线衍射分析
X-RAY DIFFRACTION ANALYSIS ON THE THICKNESS EFFECT OFγ/γ’ LATTICE MISMATCHE IN NICKEL BASE SINGLE CRYSTAL SUPERALLOY DD10

查看参考文献19篇

文摘 利用四轴X射线衍射仪(XRD)测定片状DD10镍基单晶高温合金减薄至不同厚度时基体相(γ)和沉淀强化相(γ′)的晶格常数。根据减薄过程中两相间约束变化得到晶格常数和错配度变化规律,计算出合金从三维块体错配应力状态向二维平面应力状态转化达到失稳状态的临界厚度以及与不同应力状态对应的晶格错配度。依照一定的假设条件,推算出与应力松弛条件对应的无错配应力状态下两相的晶格常数。分析结果表明:合金减薄达到临界厚度后,γ′相晶格常数随厚度减小而线性变小,γ相晶格常数无明显变化,与此对应的晶格错配度绝对值变大;减薄过程伴随γ/γ′两相间约束的减弱和相间微观应力松弛,晶格取向差和晶体嵌镶度增大,表层应力状态向平面应力状态转化。测量得到的临界厚度与无错配应力状态下的晶格常数可为高温合金单晶材料的应用设计和残余应力测试提供参考.
其他语种文摘 The lattice constants of the matrix phase 7 and the precipitated phaseγ’ in a waferlike nickel-base single crystal superalloy DD10 were determined by four-axis X-ray diffractometer (XRD).The variations of the lattice constants and lattice mismatches ofγandγ’ phases in the alloy wafer with different thicknesses,i.e.,different interphase restriction conditions were obtained.A critical thickness of the alloy wafer to reach an unstable stress state was defined based on the observed changes of lattice mismatch associated with a transformation of stress state from the 3D bulk state to 2D plane state.The lattice mismatches corresponding to different mismatch stress states were calculated. The lattice constants of theγandγ’ phases under a relaxed non-mismatch stress state were evaluated based on certain assumptions.The results showed that after the thickness of the alloy wafer reached the critical value,the lattice constant of theγ’ phase decreased linearly with the decrease of the thickness,whereas that of theγphase kept nearly constant,resulting in a linear increase of the absolute value of lattice mismatch.Accompanied with the thinning process,the crystal lattice misorientation and the mosaicity increased,theγ/γ’ interphase restraint reduced and the interphase stress relaxed, and the measured stress state changed to the plane state.The estimated critical thickness and the lattice constants under non-mismatch stress state could provide references for the design of the components and the measurement of the residual stress in the superalloy.
来源 金属学报 ,2011,47(11):1418-1425 【核心库】
DOI 10.3724/sp.j.1037.2011.00307
关键词 镍基单晶高温合金 ; 晶格常数 ; 晶格错配度 ; XRD
地址

中国科学院金属研究所, 沈阳材料科学国家(联合)实验室, 沈阳, 110016

语种 中文
文献类型 研究性论文
ISSN 0412-1961
学科 金属学与金属工艺
基金 国家自然科学基金项目 ;  国家863计划
文献收藏号 CSCD:4420404

参考文献 共 19 共1页

1.  Glatzel U. Scr Metall,1989,23:1839 被引 14    
2.  Kuhn H A. Acta Metall,1991,39:2783 被引 2    
3.  Socrate S. Acta Metall Mater,1993,41:2185 被引 34    
4.  Mukherji D. Strunz P, Wroblewski T, Fuess H, Rosler J. Scr Mater,2003,48:333 被引 8    
5.  孟凡来. 材料研究学报,2007,21:228 被引 1    
6.  胡壮麒. 镍基合金中γ'相界面的强化设计. 金属学报,2002,38:1121 被引 17    
7.  Marty B. Acta Mater,1997,45:791 被引 6    
8.  Wu E D. J Phys: Condens Matter,2008,20:104255 被引 3    
9.  Merchant H D. J Electron Mater,1997,26:833 被引 1    
10.  Hyun S. Appl Phys Lett,2003,83:4411 被引 1    
11.  Gilles R. Acta Mater,2006,54:1313 被引 1    
12.  Mukherji D. Scr Mater,1997,36:1233 被引 2    
13.  Muller L. Acta Metall Mater,1992,40:1321 被引 33    
14.  Muller L. Scr Metall,1992,26:1298 被引 1    
15.  Floreen S. Eng Fract Mech,1979,11:55 被引 1    
16.  岳珠峰. 镍基单晶合金的厚度效应. 金属学报,1997,33:265 被引 2    
17.  Orosz R. Oxid Met,2007,68:165 被引 1    
18.  Pant P. Acta Mater,2003,51:3243 被引 1    
19.  Ganghoffer J F. Scr Metall Mater,1991,25:2491 被引 5    
引证文献 1

1 李博帅 焊后热处理及长时热暴露对HT700高温合金摩擦焊接接头组织的影响 动力工程学报,2021,41(4):337-344
被引 0 次

显示所有1篇文献

论文科学数据集
PlumX Metrics
相关文献

 作者相关
 关键词相关
 参考文献相关

版权所有 ©2008 中国科学院文献情报中心 制作维护:中国科学院文献情报中心
地址:北京中关村北四环西路33号 邮政编码:100190 联系电话:(010)82627496 E-mail:cscd@mail.las.ac.cn 京ICP备05002861号-4 | 京公网安备11010802043238号