连续纤维增强含二氮杂萘酮联苯结构聚芳醚砜酮树脂基复合材料的界面
INTERFACIAL STUDIES OF CONTINUOUS FIBERS REINFORCED POLY(AROMATIC ETHERS)CONTAINING PHTHALAZINONE MOIETIES
查看参考文献39篇
|
文摘
|
利用射频感性耦合冷等离子体(ICP)处理技术改性连续纤维表面,分别采用X射线光电子能谱(XPS)、原子力显微镜(AFM)及动态接触角分析(DCA)系统研究了等离子体处理时间、放电气压、放电功率等工艺参数对连续碳纤维、芳纶纤维和对亚苯基苯并二噁唑(PBO)纤维的表面化学成分、表面形貌、表面粗糙度及表面自由能的影响.研究结果表明,等离子体处理能够在连续纤维表面引入O—C O基等极性基团,使纤维表面极性基团的含量增加,等离子体对纤维表面具有明显的刻蚀作用,经等离子体处理后纤维的表面粗糙度增加,表面自由能增大,纤维的浸润性能得到明显改善.利用等离子体对纤维进行表面处理时应选择合适的等离子体处理工艺参数.在此基础上,采用层间剪切强度(ILSS)、吸水率和扫描电子显微镜(SEM)系统地分析了连续纤维增强可溶性聚芳醚(PPESK)树脂基复合材料的界面粘结与破坏机理.结果表明,冷等离子体处理能够使连续纤维增强PPESK树脂基复合材料的ILSS增大,吸水率降低,复合材料的界面粘结性能得到明显改善.在应力的作用下,复合材料的破坏模式由未处理的界面脱黏破坏转变为冷等离子体处理后树脂基体的破坏. |
|
其他语种文摘
|
The surface modification of continuous fiber was conducted by the inductive coupling radio frequency cold plasma(ICP)technique.The influence of the plasma parameters,such as treatment time,discharge pressure,power,etc.on the surface chemical composition,surface morphology,surface roughness and surface free energy of continuous fiber was systematically studied by X-ray photoelectron spectroscopy(XPS),atomic force microscopy(AFM)and dynamic contact angle analysis(DCAA),respectively.Results showed that the plasma treatment introduced some polar groups such as O—C O onto the continuous fiber surface,increasing the percentage of surface polar groups;the plasma etched the fiber surface obviously,enhancing the surface roughness and surface free energy and improving the wettability of the fiber distinctly.Plasma treatment conditions should be appropriate during surface modification of fibers by clod plasma.After CF was treated for 5 min,CF surface polar group was increased to a relatively higher level.However,the effect of plasma etching on CF surface is relatively slower.After CF was treated for 5 min,CF surface roughness was changed a little.However,after CF was treated for more than 15 min CF surface roughness was increased significantly.Based on the study above,the interfacial adhesion and fracture mechanism of continuous fiber reinforced soluble polyaromatic ether resin composites was also systematically analysed by interlaminar shear strength(ILSS),water absorption and scanning electron microscopy(SEM)measurements.It was found that CF reinforced poly(phthalazinone ether sulfone ketone)(PPESK)composite interfacial adhesion mechanism analysis indicats that both chemical bonding and mechanical interlocking interaction has a positive effect on composite interfacial adhesion,however,mechanical interaction has a dominant effect on composite interfacial adhesion than chemical bonding interaction.Armos aramid fiber composite interlaminar shear strength increased from 59.5 MPa for untreated sample to 68.8 MPa for plasma treated for 10 min under discharge power at 200 W,with an increase of 15.6%.The water absorption decrease of composite also indirectly showed that oxygen plasma treatment improved composite interfacial adhesion.The primary failure mode of Armos aramid or PBO/PPESK composites shifted from interface failure to matrix fracture after oxygen plasma treatment.The interfacial adhesion of Armos aramid or PBO/PPESK composites was improved by oxygen plasma treatment due to the chemical linkage and mechanical bonding between Armos aramid or PBO fibers and PPESK matrices,and the chemical linkage effect exhibits more contribution than the mechanical bonding. |
|
来源
|
高分子学报
,2011(1):38-47 【核心库】
|
|
关键词
|
二氮杂萘酮聚芳醚树脂
;
碳纤维
;
芳纶纤维
;
聚对亚苯基苯并二噁唑(PBO)纤维
;
先进复合材料
;
表面与界面
|
|
地址
|
1.
大连理工大学化工学院, 先进聚合物基复合材料制备技术辽宁省重点实验室, 大连, 116012
2.
沈阳航空航天大学材料学院, 先进聚合物基复合材料制备技术辽宁省重点实验室, 沈阳, 110136
|
|
语种
|
中文 |
|
文献类型
|
研究性论文 |
|
ISSN
|
1000-3304 |
|
学科
|
一般工业技术 |
|
基金
|
国家自然科学基金
;
国家863计划
;
国防“十一五”基础科研项目
;
辽宁省“十一五”重点科技攻关项目
|
|
文献收藏号
|
CSCD:4288555
|
参考文献 共
39
共2页
|
|
1.
周运安. 聚对苯二甲酰对苯二胺纤维的热老化行为与机理研究.
高分子学报,2010(7):932-936
|
被引
3
次
|
|
|
|
|
2.
崔天放. 苯并二噁唑系列聚合物的合成及表征.
高分子学报,2010(2):173-178
|
被引
2
次
|
|
|
|
|
3.
余永重. 含烷基侧链聚芴基苯并二(噁)唑聚合物的合成及性能研究.
高分子学报,2009(12):1252-1258
|
被引
7
次
|
|
|
|
|
4.
蹇锡高. 含二氮杂荼酮结构新型聚芳醚系列高性能聚合物的合成与性能.
高分子学报,2003(4):469-475
|
被引
32
次
|
|
|
|
|
5.
Sun W N. ULTRAFILTRATION MEMBRANE FORMATION OF PES-C,PES AND PPESK POLYMERS WITH DIFFERENT SOLVENTS.
Chinese J Polym Sci,2009,27(2):165-172
|
被引
3
次
|
|
|
|
|
6.
陈平.
中国发明专利,CN200410050246.6,2004
|
被引
1
次
|
|
|
|
|
7.
陈平.
中国发明专利,ZL200510047183.3,2008
|
被引
1
次
|
|
|
|
|
8.
陈平.
中国发明专利,ZL200610134662.3,2009
|
被引
1
次
|
|
|
|
|
9.
陈平.
中国发明专利,CN200710081665.X,2007
|
被引
1
次
|
|
|
|
|
10.
李伟.
中国发明专利,CN200810013111.0,2008
|
被引
1
次
|
|
|
|
|
11.
Chen P.
J Appl Polym Sci,2006,102:2544-2551
|
被引
8
次
|
|
|
|
|
12.
Lu C.
J Appl Polym Sci,2007,106:1733-1741
|
被引
10
次
|
|
|
|
|
13.
Lu C.
Adv Compos Lett,2007,16:33-37
|
被引
2
次
|
|
|
|
|
14.
Lu C.
Appl Compos Mater,2008,15:157-169
|
被引
6
次
|
|
|
|
|
15.
Wang J.
Surf Coat Technol,2008,202:4986-4991
|
被引
7
次
|
|
|
|
|
16.
Wang J.
Surf Interface Anal,2008,40:1299-1303
|
被引
6
次
|
|
|
|
|
17.
王静.
芳纶纤维增强可溶性聚芳醚复合材料的制备技术,界面表征及性能研究[博士学位论文],2009
|
被引
1
次
|
|
|
|
|
18.
Zhang C S.
Appl Surf Sci,2008,254:5776-5780
|
被引
7
次
|
|
|
|
|
19.
Chen P.
Appl Surf Sci,2008,255:3153-3158
|
被引
6
次
|
|
|
|
|
20.
Chen P.
Surf Interface Anal,2009,41:38-43
|
被引
2
次
|
|
|
|
|
了解气象卫星更多信息，请访问