大气等离子喷涂制备莫来石涂层的性能
Characteristics of Mullite Coatings Prepared by Air Plasma Spraying
查看参考文献14篇
文摘
|
采用大气等离子喷涂制备莫来石涂层,对涂层进行了热震试验。以OLYCIA m3图像分析软件测定涂层孔隙率,以MH-5-VM型显微硬度仪测定涂层硬度,依照ASTMC633-79标准测定涂层结合强度,以X射线衍射(XRD)和扫描电镜(SEM)表征涂层的相组成和微观形貌。结果表明,莫来石涂层主要由变形颗粒、未熔融粉末及少量孔隙组成,涂层中没有微观裂纹;涂层中含有莫来石晶体和部分非晶态玻璃相;热震过程中,涂层中的非晶转变为晶态莫来石,同时伴随应力释放,导致涂层出现微观裂纹。 |
其他语种文摘
|
The mullite coatings were prepared by air plasma sprayed.The as-sprayed coating were carried out thermal shock experiment.The porosity and microhardness were measured by OLYCIA m3 image analysis software and MH-5-VM microhardness tester,respectively.The bond strength of mullite coatings were determined according to ASTM C633-79 standard.The composition and morphology of the mullite coatings were examined by X-ray diffraction(XRD)and scanning electron microscope(SEM).The results show that as-sprayed coating includes splats grains,partially melted powders and a few pores.The microcracks do not appear in the coating.The as-sprayed coating is largely crystal mullite and only a small quantity of amorphous phase.During thermal shock experiment,amorphous phase in coating changes to crystal mullite and gives rise to stress,leading to microcracks. |
来源
|
材料导报
,2011,25(1B):36-39 【核心库】
|
关键词
|
大气等离子喷涂
;
莫来石涂层
;
热震试验
;
非晶
|
地址
|
中国科学院兰州化学物理研究所, 固体润滑国家重点实验室, 兰州, 730000
|
语种
|
中文 |
文献类型
|
研究性论文 |
ISSN
|
1005-023X |
学科
|
金属学与金属工艺 |
基金
|
国家自然科学基金创新研究群体项目
|
文献收藏号
|
CSCD:4236223
|
参考文献 共
14
共1页
|
1.
郭宏波. 先进航空发动机热障涂层技术研究进展.
中国材料进展,2009,28(9/10):18
|
被引
1
次
|
|
|
|
2.
周洪. 等离子喷涂热障涂层的隔热性分析.
中国有色金属学报,2007,17(10):1609
|
被引
17
次
|
|
|
|
3.
Miller R A. Thermal barrier coatings for aircraft engines:History and directions.
J Thermal Spray Techn,1997,6(1):35
|
被引
114
次
|
|
|
|
4.
Lee K N. Current status of environmental barrier coatings for Si-based ceramics.
Surf Coat Techn,2000(133/134):1
|
被引
40
次
|
|
|
|
5.
吴子健.
热喷涂技术与应用,2006:264
|
被引
1
次
|
|
|
|
6.
陈冬. 莫来石的研究进展.
矿产与地质,2004,18(101):52
|
被引
12
次
|
|
|
|
7.
侯平均. 微弧等离子喷涂制备空心莫来石隔热涂层研究.
兵工学报,2009,30(8):1108
|
被引
3
次
|
|
|
|
8.
谭宏斌. 莫来石物理性能研究进展.
山东陶瓷,2008,31(4):24
|
被引
4
次
|
|
|
|
9.
Mab T. Mechanical properties of mullite.
J Am Ceram Soc,1983,66(10):699
|
被引
4
次
|
|
|
|
10.
曹雪强.
热障涂层材料,2007:161
|
被引
1
次
|
|
|
|
11.
Oberste Berghaus J. High-velocity oxy-fuel(HVOF)suspension spraying of mullite coatings.
J Thermal Spray Techn,2008,17(5/6):671
|
被引
2
次
|
|
|
|
12.
Ramaswamy P. Thermal shock characteristics of plasma sprayed mullite coatings.
J Thermal Spray Techn,1998,7(4):497
|
被引
7
次
|
|
|
|
13.
Cano C. Mullite/ZrO_2coatings produced by flame spraying.
J Eur Ceram Soc,2008,28(11):2191
|
被引
2
次
|
|
|
|
14.
Lee K N. New generation of plasma-sprayed mullite coatings on silicon carbide.
J Am Ceram Soc,1995,78(3):705
|
被引
28
次
|
|
|
|
|