帮助 关于我们

返回检索结果

低功率氩电弧加热发动机的数值模拟
Numerical modeling of low-power argon arcjet thruster

查看参考文献8篇

贾少霞 1   王海兴 1 *   陈熙 2   潘文霞 3   汤海滨 1  
文摘 采用可求解可压缩流动与传热的全速度SIMPLE算法, 对低功率氩电弧加热发动机内部的传热与流动进行了数值模拟, 获得了电弧加热发动机内的温度、速度、马赫数及流线分布. 计算结果表明: 电弧加热发动机内最高温度出现在阴极下游附近中心轴线处, 这是因为电弧在阴极表面收缩形成阴极弧点, 从而焦耳热成为该高温区的主要加热机制; 沿着发动机中心轴线, 气体温度和速度开始时随着距阴极距离的增加而迅速增加, 然后在等离子体流向喷管出口的过程中, 气体温度和速度逐渐下降. 此外还详细考察了弧电流变化对电弧加热发动机内部传热与流动特性的影响, 计算获得的发动机流量和比冲与实验结果基本一致.
其他语种文摘 In this paper, modeling study is performed to reveal the plasma flow and heat transfer characteristics of the low-power argon arcjet thruster. The all-speed SIMPLE algorithm is used for the solution of the governing equations. Computed results are presented concerning the temperature, velocity, Mach number and streamline distributions within the thruster nozzle and concerning the current density distributions on the anode-nozzle surface under typical operating conditions. It is found that the heating of the gaseous propellant takes place mainly in the cathode and constrictor regions and the highest plasma temperature appears at the location near the cathode tip where the current density assumes its maximum value. The plasma axial-velocity and temperature profiles along the nozzle axis increases rapidly at first and then decreases gradually as the plasma flows toward the thruster exit. The effects of different arc currents on the flow and heat transfer characteristics within the thruster nozzle are also investigated. Under typical operating conditions studied here, the computed specific impulses and mass flow rates of the argon arcjet thruster are roughly consistent with corresponding experimental data.
来源 强激光与粒子束 ,2010,22(7):1539-1542 【核心库】
DOI 10.3788/hplpb20102207.1539
关键词 电弧加热发动机 ; 等离子体 ; 流动与传热 ; 数值模拟
地址

1. 北京航空航天大学宇航学院, 北京, 100191  

2. 清华大学工程力学系, 北京, 100084  

3. 中国科学院力学研究所, 北京, 100190

语种 中文
文献类型 研究性论文
ISSN 1001-4322
学科 航天(宇宙航行)
基金 国家自然科学基金项目
文献收藏号 CSCD:3924757

参考文献 共 8 共1页

1.  吴汉基. 美国电弧加热发动机的研究计划. 上海航天,1997(6):45-50 被引 4    
2.  Butler G W. Single and two fluid simulations of arcjet performance. AIAA Paper 1992-3104,1992 被引 1    
3.  Martinez-Sanchez M. Arcjet modeling: status and prospects. Journal of Propulsion and Power,1996,12(6):1035-1043 被引 10    
4.  Auweter-Kurtz M. Arcjet thruster development. Journal of Propulsion and Power,1996,12(6):1007-1083 被引 1    
5.  Han Peng. Modeling of the subsonic-supersonic flow and heat transfer in a DC arc plasma torch. Plasma Chemistry and Plasma Processing,2001,21(2):249-264 被引 10    
6.  Aithal S M. Effects of arc attachment on arcjet flows. AIAA Paper 1996-3295,1996 被引 1    
7.  Babu V. Numerical simulation of a hydrogen arcjet. Journal of Propulsion and Power,1996,12(6):1114-1122 被引 2    
8.  Butler G W. Non-equilibrium flow phenomena in low power hydrogen arcjets. AIAA 1995-2819,1995 被引 1    
引证文献 4

1 彭翊 洛伦兹力对自由燃烧弧和壁稳非转移弧流场的影响 强激光与粒子束,2013,25(1):52-56
被引 2

2 魏延明 低功率氮氢混合物电弧加热发动机模拟研究 空间控制技术与应用,2015,41(1):1-8
被引 0 次

显示所有4篇文献

论文科学数据集
PlumX Metrics
相关文献

 作者相关
 关键词相关
 参考文献相关

版权所有 ©2008 中国科学院文献情报中心 制作维护:中国科学院文献情报中心
地址:北京中关村北四环西路33号 邮政编码:100190 联系电话:(010)82627496 E-mail:cscd@mail.las.ac.cn 京ICP备05002861号-4 | 京公网安备11010802043238号