电化学腐蚀对翅片管换热器性能的影响
Effect of electrochemical corrosion on performance of tube-fin heat exchanger
查看参考文献15篇
文摘
|
翅片管换热器的铜管与铝翅片之间容易发生电化学反应,在铝翅片表面形成一层三氧化二铝,增大换热器传热热阻,影响换热器乃至整个空调系统的性能.对翅片管换热器分别进行48 h和96 h的盐雾腐蚀实验,然后对腐蚀前后的实验样件测试其传热及压降特性,结果表明,翅片管蒸发器经盐雾腐蚀以后,其风阻变化在5 Pa以内,而换热量最多会降低12.5%,总的传热系数最多会减少16.6%,传热热阻最多会增加20%. |
其他语种文摘
|
Electrochemical corrosion takes place between the copper tube and aluminum fin of tube-fin heat exchanger easily,forming a high thermal resistance layer of Al_2O_3.Therefore,the performance of the heat exchanger and the entire air conditioning system will be affected.In this paper,48 h and 96 h salt spray corrosion tests were made on the tube-fin heat exchanger respectively.And the performance of the heat exchanger before and after salt spray corrosion was tested.It was found that the change of air pressure drop was less than 5 Pa.The capacity and overall heat transfer coefficient of the heat exchanger decreased by 12.5% and 16.6% after corrosion respectively.The thermal resistance of the heat exchanger increased by 20% at most. |
来源
|
化工学报
,2010,61(1):22-26 【核心库】
|
关键词
|
翅片管换热器
;
电化学腐蚀
;
传热系数
;
热阻
|
地址
|
1.
上海交通大学制冷与低温工程研究所, 上海, 200240
2.
国际铜业协会广州代表处, 广东, 广州, 510620
|
语种
|
中文 |
文献类型
|
研究性论文 |
ISSN
|
0438-1157 |
学科
|
一般工业技术 |
文献收藏号
|
CSCD:3804432
|
参考文献 共
15
共1页
|
1.
徐志明. 管式换热器积灰特性的实验研究.
工程热物理学报,2002,23(2):203-205
|
被引
7
次
|
|
|
|
2.
Li Y. Impact of fouling on the performance of filter-evaporator combinations.
International Journal of Refrigeration,2007,30(3):489-498
|
被引
4
次
|
|
|
|
3.
Siegel J A. Predicting particle deposition on HVAC heat exchangers.
Atmospheric Environment,2003,37(39):5587-5596
|
被引
6
次
|
|
|
|
4.
浦晖. 微生物污垢对翅片管换热器空气侧换热和压降特性的影响.
上海交通大学学报,2008,42(3):404-408
|
被引
5
次
|
|
|
|
5.
Abd-Elhady M S. Optimization of flow direction to minimize particulate fouling of heat exchangers.
Heat Transfer Engineering,2009,30(10/11):895-902
|
被引
5
次
|
|
|
|
6.
Casanueva J F. Portable pilot plant for evaluating marine biofouling growth and control in heat exchangers-condensers.
Water Science and Technology,2003,47(5):99-104
|
被引
2
次
|
|
|
|
7.
Nebot E. In situ experimental study for the optimization of chlorine dosage in seawater cooling systems.
Applied Tnermal Engineering,2006,26(16):1893-1900
|
被引
11
次
|
|
|
|
8.
Kuznicka B. Erosion-corrosion of heat exchanger tubes.
ENGINEERING FAILURE ANALYSIS,2009,16:2382-2387
|
被引
6
次
|
|
|
|
9.
衡世权. The formation mechanism and preventive measure of heat exchanger corrosion fouling.
节能,2004(4):28-30
|
被引
1
次
|
|
|
|
10.
何源. Refrigeration unit heat interchanger corrosion and prevention.
洁净与空调技术,2008(4):36-39
|
被引
1
次
|
|
|
|
11.
王育忠. Reasons and countermeasures of corrosion for aluminum tube heat-exchanger.
石化技术,2005,12(3):53-54
|
被引
2
次
|
|
|
|
12.
.
GB/T 10125-1997
|
被引
1
次
|
|
|
|
13.
Moffat R J. Describing the uncertainties in experimental results.
Experimental Thermal and Fluid Science,1998,1(1):3-17
|
被引
378
次
|
|
|
|
14.
.
JB/T 6914-93
|
被引
1
次
|
|
|
|
15.
Wang C C. Data reduction for air-side performance of fin-and-tube heat exchangers.
Experimental Thermal and Fluid Science,2000,21(4):218-226
|
被引
12
次
|
|
|
|
|