帮助 关于我们

返回检索结果

射流泵极限工况下空化流动
Cavitating Flow in Jet Pump under the Operating Limits

查看参考文献12篇

龙新平 1 *   姚昊 1   赵建福 2  
文摘 极限工况发生时,液体射流泵喉管中段至末端的汽液两相空化流动为均相泡状流.基于定常、等温及水平流动假设和Wood声速公式,导出极限工况发生时射流泵喉管中段至末端一维均相泡状流的控制方程组.依据该控制方程结合射流泵壁面沿程压力测试结果,计算喉管中段至末端液汽两相流动的马赫数.从喉管的中段至末端液汽两相流动的马赫数逐渐增加,在压力最低点附近达到最大,其最大值为0.94,十分接近1.进一步分析表明,极限工况发生时,射流泵喉管中段至末端液汽两相空化流表现为两相临界流动,其流速达到当地液汽两相流声速,流动出现臃塞,从而导致一定工作压力下吸入流量不再随出口压力的降低而增加,而是保持不变.揭示射流泵极限工况发生的机理,对其深入研究具有重要意义.
其他语种文摘 The liquid-vapor two-phase cavitating flow from the middle section to the end of throat tube is observed and verified to be homogeneous froth flow when jet pump works under the operating limits. Based on the assumption of the steady isothermal horizontal flow and the Wood sound velocity equation, the one-dimensional governing equation of homogeneous froth flow from the middle section to the end of throat tube under the operating limits, is derived. With the aid of the measurement data of pressure distribution along the wall of the jet pump, the Mach number of the liquid-vapor two-phase flow from the middle section to the end of throat tube is calculated by the derived governing equation. It is found that the Mach number increases gradually from the middle section to the end of throat tube, and reaches the maximum value 0.94, very close to 1, at nearby the lowest point of pressure. Further analysis indicates that under the operating limits, the liquid-vapor cavitating flow from the middle section to the end of throat tube performs as critical two-phase flow, and the flow velocity reaches the local sound velocity of the liquid-vapor two-phase flow. The flow is choked and results in the appearance of the operating limits that the entrained flow rate will keep unchanged and not increase with the decrease of outlet pressure under a certain driving pressure. The mechanism of flow within a jet pump under operating limits is revealed and this is of significance to the further research work.
来源 机械工程学报 ,2009,45(12):59-64 【核心库】
DOI 10.3901/jme.2009.12.059
关键词 射流泵 ; 空化 ; 极限工况 ; 汽液两相流 ; 临界流 ; Wood声速公式
地址

1. 武汉大学动力与机械学院, 湖北, 武汉, 430072  

2. 中国科学院力学研究所, 国家微重力实验室, 北京, 100190

语种 中文
文献类型 研究性论文
ISSN 0577-6686
学科 机械、仪表工业
基金 国家自然科学基金
文献收藏号 CSCD:3791454

参考文献 共 12 共1页

1.  龙新平. 射流泵汽蚀问题研究综述. 水泵技术,2003(4):33-38 被引 8    
2.  KUDIRKA A A. Jet pump cavitation with ambient and high-temperature water. Journal of Fluids Engineering,1979,101(1):93-99 被引 8    
3.  MARINI M. Low area ratio aircraft fuel jet-pump performance with and without cavitation. Journal of Fluids Engineering,1992,114(4):626-631 被引 3    
4.  CUNNINGHAM R G. Jet pump cavitation. Trans ASME,1970,92(3):483-494 被引 3    
5.  BONNINGTON S T. Jet pumps and ejectors:A state of the art reviews and bibliographer,1972 被引 2    
6.  LU H. Mechanism and calculation theory of jet pump cavitation. Sci China Ser A(in English),1987,11:1174-1187 被引 1    
7.  WINOTO S H. Limiting flow condition in water jet pump. Proc.XIX IAHR Sym on Hydraulic Machinery and Cavitation Singapore,1998:852-866 被引 1    
8.  姚昊. 液体射流泵极限工况的机理研究,2006 被引 1    
9.  BRENNEN C E. Cavitation and bubble dynamics,1995 被引 119    
10.  BRENNEN C E. Fundamentals of multiphase flows,2005 被引 5    
11.  黄素逸. 汽液两相流动与传热,1988 被引 5    
12.  郭烈锦. 两相与多相流动力学,2002 被引 102    
引证文献 2

1 綦耀光 煤层气井负压射流快速排煤粉装置研究 中国矿业大学学报. 自然科学版,2014,43(1):72-78
被引 4

2 李贵东 基于大涡模拟的射流式离心泵射流器内部的流动特性 排灌机械工程学报,2017,35(5):369-374
被引 5

显示所有2篇文献

论文科学数据集
PlumX Metrics
相关文献

 作者相关
 关键词相关
 参考文献相关

iAuthor 链接
赵建福 0000-0002-6693-2594
版权所有 ©2008 中国科学院文献情报中心 制作维护:中国科学院文献情报中心
地址:北京中关村北四环西路33号 邮政编码:100190 联系电话:(010)82627496 E-mail:cscd@mail.las.ac.cn 京ICP备05002861号-4 | 京公网安备11010802043238号