帮助 关于我们

返回检索结果

挤压AM50(-Ca)镁合金的显微组织与力学性能研究
Microstructure and mechanical properties of As-extruded AM50(-Ca)

查看参考文献11篇

张久文 1   陈荣石 2   周文龙 1   韩恩厚 2  
文摘 研究了挤压AM50(-Ca)镁合金的微观组织和力学性能.研究发现添加钙在AM50合金中生成新的Al_2Ca相,并细化合金的晶粒尺寸.大于2wt.%的钙使铸态AMS0的晶粒尺寸从200 μm减小到40 μm,使挤压态AM50的晶粒尺寸从15 μm减小到7.5 μm.含钙量较少时,晶粒内仍含有少量的Mg_(17)Al_(12)相,Al_2Ca相主要分布在晶界;含钙量多于2wt.%时,合金中的Mg_(17)Al_(12)完全消失,除晶界处的Al_2Ca相外,在晶粒内部出现大量的针状Al_2Ca相.加钙提高了AM50合金的低温抗拉强度,同时在所有试验温度下合金的屈服强度得到提升.
其他语种文摘 The effects of Ca addition on the microstructure and mechanical properties of the extruded AM50 magnesium alloy have been studied. The results show thai the Ca addition can reduce the quantity of Mg_(17)Al_(12)phase and form a new Al_2Ca phase distributing along grain boundaries. When Ca is added with an amount of more than 2wt. % , needle -shaped Al_2Ca precipitates are observed inside grain interiors, and the grain sizes of both as -cast and as - extruded AM50 alloy are decreased from 200μm and 15μm to 40μm and 7.5μm, respectively. It is found that the yield strength of the extruded AM50 alloy are improved with increasing Ca content in the studied temperature range, while the improvement in ultimate strength can be observed only at low temperature.
来源 材料科学与工艺 ,2007,15(1):141-144 【核心库】
关键词 M50 ; Ca ; 变形镁合金 ; 显微组织 ; 拉伸性能
地址

1. 大连理工大学,材料工程系, 辽宁, 大连, 116023  

2. 中国科学院金属研究所, 辽宁, 沈阳, 110016

语种 中文
文献类型 研究性论文
ISSN 1005-0299
学科 金属学与金属工艺
基金 国家863计划 ;  辽宁省博士启动基金
文献收藏号 CSCD:2809270

参考文献 共 11 共1页

1.  POLMEAR I J. Magnesium alloys and applications. Mater Sci Tech,1994(10):1-16 被引 244    
2.  MORDIKE B L. Magnesium Properties-applications-potential. Mater Sci Eng A,2001,302:37 被引 1179    
3.  于琨. 变形镁合金的研究、开发及应用. 中国有色金属学报,2003,13(2):277-288 被引 4    
4.  Tatiana V Larionova. A terrmry phase observed in rapidly solidified MgCa-Zn alloys. Scripta Mater,2001,45:7-21 被引 20    
5.  NINORMIYA R. Improved heat resistance of Mg-Al alloys by the Ca addition. Acta Metall Mater,1995,43(2):669-674 被引 2    
6.  PEKGULERYUZ M O. Creep resistant magnesium alloys for powertrain application. Advanced Eng Mater,2003,5(12):866-878 被引 56    
7.  QUDONG Wang. Effects of Ca addition on the micmstructure and mechanical properties of AZ91 magnesium alloy. J Mater Sci,2001,36:3035-3040 被引 34    
8.  LUO A. Cast Magnesium alloys for elevated temperature applications. J Mater Sci,1994,29:5259-5271 被引 166    
9.  SAKAMOTO M. Journal of Mater Sci Letters,1997,16(12):1048-1051 被引 33    
10.  WANG R M. An investigation on the microstructure of AM50 magnesium alloy. Mater Sei Eng,2003,355:201-207 被引 1    
11.  Chunjiang Ma. Tensile properties of extruded ZK60-RE alloys Mater Sci Eng. Mater Sci Eng,2003,349(1):213-217 被引 1    
引证文献 1

1 张孟军 热挤压对铸态Mg-3.5Al-3.5Ca-0.6Mn合金组织与性能的影响 机械工程材料,2017,41(5):32-37,42
被引 1

显示所有1篇文献

论文科学数据集
PlumX Metrics
相关文献

 作者相关
 关键词相关
 参考文献相关

版权所有 ©2008 中国科学院文献情报中心 制作维护:中国科学院文献情报中心
地址:北京中关村北四环西路33号 邮政编码:100190 联系电话:(010)82627496 E-mail:cscd@mail.las.ac.cn 京ICP备05002861号-4 | 京公网安备11010802043238号