炭纤维增强聚醚醚酮复合材料在水润滑下的摩擦学行为
THE TRIBOLOGICAL PROPERTIES OF CARBON FIBER REINFORCED PEEK COMPOSITES UNDER WATER LUBRICATION
查看参考文献11篇
文摘
|
考察了炭纤维及PTFE增强PEEK复合材料在干摩擦和水润滑下的摩擦学性能,并研究了该复合材料在两种条件下的磨损机理.结果表明,干摩擦下复合材料的摩擦系数和磨损率随负荷的增加不断减小;水润滑下复合材料的摩擦系数随负荷的变化不大,磨损率随负荷的增加而增大.干摩擦下,复合材料的磨损以粘着磨损和磨粒磨损为主.水润滑条件下,磨损表面比较光滑,仅有微切削的痕迹,磨损方式以轻微磨粒磨损为主.干摩擦条件下,摩擦对偶表面仅有轻微的犁沟形成,表面形成一层薄而均匀且结合紧密的转移膜.水润滑下,对偶表面犁沟较深,犁削作用明显,转移膜的形成被明显抑制.水的冷却作用使得向摩擦对偶的粘着转移明显减轻,同时由于摩擦表面吸附水膜的边界润滑作用,显著改善复合材料的摩擦磨损性能. |
其他语种文摘
|
The tribological behavior of carbon fiber and polytetrafluoroethylene reinforced; Polyetheretherketone composites were comparatively evaluated under dry and water lubricate*! sliding. The wear mechanisms of PEEK composite were discussed as well. The result indicate that water can reduce the wear rate of PEEK composite. The wear rates of composite show much lower under water lubrication than under dry sliding, owing to the boundary lubrication effect of the water-adsorbed layer and the cooling effect of water. The wear of PEEK composites are characterized by adhesion and abrasive under dry sliding. Contrary to the above, a small amount of exposed and locally polished fibers are observed on the worn composite surface under water lubrication. In this case the micro-scuffing is seen. The thin coherent and compact transfer film on the counterpart stainless steel formed under dry sliding is markedly prevented under water lubrir* tion. |
来源
|
高分子材料科学与工程
,2005,21(2):208-212 【核心库】
|
关键词
|
聚醚醚酮
;
复合材料
;
炭纤维
;
水润滑
;
转移膜
|
地址
|
1.
中国科学院兰州化学物理研究所, 固体润滑国家重点实验室, 甘肃, 兰州, 730000
2.
兰州有色金属建筑研究院, 甘肃, 兰州, 730000
|
语种
|
中文 |
文献类型
|
研究性论文 |
ISSN
|
1000-7555 |
学科
|
一般工业技术 |
基金
|
国家自然科学基金
;
浙江大学流体传动及控制国家重点实验室基金
;
中国科学院国防科技创新基金
|
文献收藏号
|
CSCD:1916676
|
参考文献 共
11
共1页
|
1.
张人佶. 张人佶 (ZHANG Ren-ji).
材料研究学报,2002,1(16):1-8
|
被引
1
次
|
|
|
|
2.
Flock J. a.
Wear,1999,225:304-311
|
被引
18
次
|
|
|
|
3.
Hanchi J. a.
Wear,1997,203/204:380-386
|
被引
13
次
|
|
|
|
4.
Briscoe B J. a.
Wear,1986,108:357-374
|
被引
19
次
|
|
|
|
5.
Voss H. Wear 1987.
Wear,1987,116:1-18
|
被引
7
次
|
|
|
|
6.
Voort J V. a.
Wear,1995,181/183:212-221
|
被引
14
次
|
|
|
|
7.
Wang Q H. a.
Wear,2000,243:140-146
|
被引
34
次
|
|
|
|
8.
Wang Q H. a.
Wear,1997,209:316-321
|
被引
15
次
|
|
|
|
9.
Xiong D S. a.
Wear,2001,250:242-245
|
被引
37
次
|
|
|
|
10.
刘家俊. 刘家俊 (LIU Jia-jun).
材料磨损原理及其耐磨性,1993:290
|
被引
1
次
|
|
|
|
11.
Lancaster J K. a.
Wear,1972,203:15-330
|
被引
1
次
|
|
|
|
|