帮助 关于我们

返回检索结果

Reaction degree of composition B explosive with multi-layered compound structure protection subjected to detonation loading

查看参考文献24篇

文摘 The explosive reaction degree and protection from explosions are concerns in the military field. In this work, the reaction degree of the composition B explosive was investigated experimentally. Multi-layered compound structures were used as barriers to weaken the blast loads. A comprehensive experiment using a high-speed camera and image processing techniques, side witness plates, and bottom witness plates was presented. Using the experimental fragment velocities, fragment piercing patterns, and damage characteristics, the reaction degree of the explosive impeded by different multi-layered compound structures could be precisely differentiated. Reaction parameters of the explosive obstructed by compound structures were obtained by theoretical analysis and numerical simulations. Unlike the common method in which the explosive reaction degree is only distinguished based on the initial pressure amplitude trsnsmitted into the explosive, a following shock wave reflected from the side steel casing was also considered. Different detonation growth paths in the explosive formed. Therefore, all these shock wave propagation characteristics must be considered to analyze the explosive response impeded by compound structures.
来源 Defence Technology ,2021,17(2):315-326 【核心库】
DOI 10.1016/j.dt.2020.02.004
关键词 Reaction degree ; Explosive protection ; Compound structure ; Comprehensive experiment
地址

Beijing Institute of Technology, State Key Laboratory of Explosion Science and Technology, Beijing, 100081

语种 英文
文献类型 研究性论文
ISSN 2096-3459
学科 武器工业
基金 support received from the National Natural Science Foundation of China
文献收藏号 CSCD:6959788

参考文献 共 24 共2页

1.  Colclough M E. A novel tuneable effects explosive charge. 2012 insensitive munitions & energetic materials technology symposium,2012 CSCD被引 2    
2.  Haskins P. Controllable output warhead. U.S. Patent. 9(109),2015:865 CSCD被引 1    
3.  Reynolds M. Development of tuneable effects warheads. Defence Technol,2016,12(3):255-262 CSCD被引 14    
4.  Center N S W. Hazard assessment tests for non-nuclear munitions. Indian Head, MD: Military Standard No. MILSTD-2105B,1994 CSCD被引 1    
5.  April Held M. Initiation of covered high explosives has many facettes. Proceedings of the third European armoured fighting vehicle symposium,1998 CSCD被引 1    
6.  Test U A. Evaluation command. Typical reactive armor safety tests. Test operations procedure No. TOP-2-2-623,1993 CSCD被引 1    
7.  Shin H. Material design guidelines for explosive confinements to control impact shock-induced detonations based on shock transmission/reflection analysis. Int J Impact Eng,2003,28(5):465-478 CSCD被引 1    
8.  Blommer E J. Explosive attenuating structure for use inside missiles and the like. U.S. Patent 1991:4.989:493 CSCD被引 1    
9.  Campbell A W. Shock initiation of solid explosives. Phys Fluid,1961,4(4):511-521 CSCD被引 7    
10.  Becuwe A. Low-sensitivity explosive compounds for low vulnerability warheads. Propellants, Explos Pyrotech,1993,18(1):1-10 CSCD被引 11    
11.  Shin H. A numerical study on the detonation behaviour of double reactive cassettes by impacts of projectiles with different nose shapes. Int J Impact Eng,2003,28(4):349-362 CSCD被引 4    
12.  Li D. Experimental study on the combined damage of multi-layered composite structures subjected to close-range explosion of simulated warheads. Int J Impact Eng,2018,114:133-146 CSCD被引 12    
13.  Orlenko L P. Fizika vzryva (physics of explosion), Vol. vol. 1 CSCD被引 1    
14.  Liu J. Influence of layer number and air gap on the ballistic performance of multi-layered targets subjected to high velocity impact by copper EFP. Int J Impact Eng,2018,112:52-65 CSCD被引 5    
15.  Meyers M A. Dynamic behavior of materials,1994 CSCD被引 171    
16.  Chen J. Shock-induced detonation of high explosives by high velocity impact. J Mech Mater Struct,2007,2(9):1701-1721 CSCD被引 8    
17.  Derun Cxwkl. Characteristics of attenuation of shock waves in barriers of different materials. Acta Armamentarii,1991:2 CSCD被引 1    
18.  Haifu W. Properties of shock pressure caused by explosion loads in polyurethane foam. Explos Shock Waves,1999:1 CSCD被引 1    
19.  Erkman J O. Attenuation of shock waves in aluminum. J Appl Phys,1967,38(13):5395-5403 CSCD被引 4    
20.  Fowles G R. Attenuation of the shock wave produced in a solid by a flying plate. J Appl Phys,1960,31(4):655-661 CSCD被引 2    
引证文献 2

1 梅瑞斌 圆柱形预制破片在爆炸冲击作用下的数值分析及结构优化 塑性工程学报,2022,29(2):197-203
CSCD被引 0 次

2 王文斌 喷涂聚脲弹性体及复合结构抗爆抗冲击性能研究进展 涂料工业,2024,54(1):81-88
CSCD被引 2

显示所有2篇文献

论文科学数据集
PlumX Metrics
相关文献

 作者相关
 关键词相关
 参考文献相关

版权所有 ©2008 中国科学院文献情报中心 制作维护:中国科学院文献情报中心
地址:北京中关村北四环西路33号 邮政编码:100190 联系电话:(010)82627496 E-mail:cscd@mail.las.ac.cn 京ICP备05002861号-4 | 京公网安备11010802043238号