5083铝合金表面单致密微弧氧化膜的制备及其性能研究
Preparation and Properties of Micro-arc Oxide Film with Single Dense Layer on Surface of 5083 Aluminum Alloy
查看参考文献23篇
|
文摘
|
采用响应曲面法对微弧氧化电解液体系进行了优化,并在5083铝合金表面进行了单致密微弧氧化涂层的制备。通过扫描电镜、X射线衍射仪、显微硬度计和极化曲线对铝合金微弧氧化膜的微观组织、显微硬度和耐蚀性进行了研究。结果表明:随着微弧氧化膜层厚度从30μm增加到90μm,烧结颗粒的尺寸从约为10μm增加到约为50μm,致密层由最初的20μm增加到70μm,陶瓷膜层中α-Al_2O_3的比例明显增加,涂层的硬度由900HV提高到1500HV。依据极化曲线和盐雾实验结果发现:随着微弧氧化时间的增加,微弧氧化膜的自腐蚀电流密度逐渐降低,钝化能力逐渐增强,膜层的耐腐蚀性能大幅度提高。 |
|
其他语种文摘
|
Marine Al-alloy 5083 owns low density,good weldability and high hardness,but it is easily suffered from pitting corrosion in sea water due to the effect of Cl-.Micro-arc oxidation (MAO) is an effective way to improve the corrosion resistance of Al-alloy.In the present study the electrolyte formula was optimized via response surface methodology so that to acquire a novel MAO coating on Al-alloy 5083,which composed of merely a dense layer.The prepare MAO coating was then characterized by scanning electron microscopy (SEM),X-ray diffraction (XRD),micro-hardness meter and dynamic polarization technology in terms of microstructure,micro-hardness and corrosion resistance.Results showed that in comparison with the coating prepared with the ordinary electrolyte,the thickness of the MAO coating increases from 30 μm to 90 μm,size of the sintered particles on MAO coating grown from 10 μm to 50 μm,and the thickness of the dense layer increased from 20 μm to 70 μm,accompanied by the increase of the percentage of α-Al_2O_3 in the MAO coating as well.The hardness of the polished MAO coating increased from 900 HV to 1500 HV.Polarization curve and salt frog test results also found that with the increasing of micro-arc oxidation time,the corrosion current density of MAO coating was gradually decreased,while its passivation ability was enhanced.Therefore,corrosion resistance of Al-alloy 5083 was increased substantially in the presence of the MAO coating composed merely of a thick dense layer. |
|
来源
|
中国腐蚀与防护学报
,2020,40(3):251-258 【核心库】
|
|
DOI
|
10.11902/1005.4537.2019.069
|
|
关键词
|
铝合金
;
微弧氧化
;
单致密层
;
耐蚀性
|
|
地址
|
1.
中国人民解放军92228部队, 北京, 100072
2.
海军研究院博士后科研工作站, 北京, 100073
3.
福建龙溪轴承(集团)股份有限公司, 漳州, 363000
4.
中国科学院金属研究所金属腐蚀与防护实验室, 中国科学院金属研究所金属腐蚀与防护实验室, 沈阳, 110016
5.
中国科学院金属研究所金属腐蚀与防护实验室, 沈阳, 110016
|
|
语种
|
中文 |
|
文献类型
|
研究性论文 |
|
ISSN
|
1005-4537 |
|
学科
|
金属学与金属工艺 |
|
文献收藏号
|
CSCD:6741209
|
参考文献 共
23
共2页
|
|
1.
黄旺福.
铝及铝合金焊接指南,2004
|
CSCD被引
9
次
|
|
|
|
|
2.
杜良. 半固态5083铝合金的二次加热组织与触变轧制.
特种铸造及有色合金,2011,31:1115
|
CSCD被引
5
次
|
|
|
|
|
3.
邱骥. 5083铝合金喷洒式微弧氧化局部膜层的制备及性能.
中国表面工程,2015,28(5):105
|
CSCD被引
2
次
|
|
|
|
|
4.
Szklarska-Smialowska Z. Pitting corrosion of aluminum.
Corros. Sci,1999,41:1743
|
CSCD被引
81
次
|
|
|
|
|
5.
易奎杨.
不同硅含量铝合金微弧氧化膜层的制备及耐磨耐腐蚀性能,2016
|
CSCD被引
2
次
|
|
|
|
|
6.
Van Tran B. Mechanism of anodic spark deposition.
Am. Ceram. Soc. Bull,1977,56:563
|
CSCD被引
3
次
|
|
|
|
|
7.
张欣宇. 等离子体微弧氧化技术及其应用.
青岛化工学院学报(自然科学版),2002,23(1):69
|
CSCD被引
1
次
|
|
|
|
|
8.
庄俊杰. 6063铝合金微弧氧化膜层的腐蚀行为研究.
腐蚀科学与防护技术,2017,29:492
|
CSCD被引
10
次
|
|
|
|
|
9.
宋希剑. 铸造高硅铝合金表面微弧氧化陶瓷层的耐磨性.
材料保护,2000,33(4):51
|
CSCD被引
13
次
|
|
|
|
|
10.
Wang Y K. Effects of additives in electrolyte on characteristics of ceramic coatings formed by microarc oxidation.
Surf. Eng,1999,15:109
|
CSCD被引
14
次
|
|
|
|
|
11.
王敏. 电解液浓度对Ba_xSr_((1-x))TiO_3微弧氧化膜微观结构及介电性能的影响.
人工晶体学报,2013,42:1584
|
CSCD被引
1
次
|
|
|
|
|
12.
贺子凯. 溶液体系对微弧氧化陶瓷膜的影响.
材料保护,2001,34(11):12
|
CSCD被引
21
次
|
|
|
|
|
13.
Saeedikhani M. Anodizing of 2024-T3 aluminum alloy in sulfuric-boric-phosphoric acids and its corrosion behavior.
Trans. Nonferrous Met. Soc. China,2013,23:2551
|
CSCD被引
17
次
|
|
|
|
|
14.
Lu C. Microstructure and tribological properties of microarc oxidation coatings on Al-Si alloy.
Key Eng. Mater,2016,703:112
|
CSCD被引
3
次
|
|
|
|
|
15.
Gulbrandsen E. The passive behaviour of Mg in alkaline fluoride solutions. Electrochemical and electron microscopical investigations.
Corros. Sci,1993,34:1423
|
CSCD被引
10
次
|
|
|
|
|
16.
李均明. 溶液电导率对LYl2铝合金微弧氧化陶瓷层的生长速度和致密度的影响.
材料热处理学报,2003,24(1):63
|
CSCD被引
12
次
|
|
|
|
|
17.
祝晓文. 铝、镁合金微弧氧化技术研究进展.
材料科学与工艺,2006,14:366
|
CSCD被引
14
次
|
|
|
|
|
18.
Liang J. Effect of potassium fluoride in electrolytic solution on the structure and properties of microarc oxidation coatings on magnesium alloy.
Appl. Surf. Sci,2005,252:345
|
CSCD被引
23
次
|
|
|
|
|
19.
Guo H F. Growth of ceramic coatings on AZ91D magnesium alloys by micro-arc oxidation in aluminate-fluoride solutions and evaluation of corrosion resistance.
Appl. Surf. Sci,2005,246:229
|
CSCD被引
48
次
|
|
|
|
|
20.
郭洪飞. 工艺条件对镁合金微弧氧化的影响.
材料科学与工艺,2006,14:616
|
CSCD被引
8
次
|
|
|
|
|
了解气象卫星更多信息，请访问