弹道修正火箭弹修正方案与射击精度研究
Research on Correction Method and Firing Accuracy of Trajectory Correction Rocket
查看参考文献18篇
文摘
|
为了提高弹药射击精度,采用脉冲推冲器和阻力板作为修正执行机构对弹道进行修正。针对不同修正方案,建立了各自对应的的六自由度弹道模型,设计了以落点预测为基础的控制策略。在分析、比较单一执行机构弹道修正特点的基础上,提出了组合修正方案。以某型火箭弹为应用对象,对不同修正方案的弹道修正效果进行了仿真实验。结果表明:脉冲推冲器对横向偏差修正效果明显,对纵向偏差修正能力不足;阻力板对纵向偏差修正效果明显,无法消除横向偏差;组合修正方案对横向偏差和纵向偏差都具有较好的修正效果,能将火箭弹的圆概率误差提高到28 m。最终通过飞行试验对上述结论进行了验证,结果验证了组合修正方案对弹道修正的有效性。 |
其他语种文摘
|
In order to improve the firing accuracy of ammunition,impulse jets and drag brakes were used to correct the trajectory. Aiming at different correct methods,the 6-degrees of freedom trajectory equations corresponding to impulse jects and drag brakes were constructed. The control method was proposed based on impact point prediction. After analyzing impulse jets and drag brakes separately,a combined correction strategy was put forward. In view of a typical rocket projectile,Monte-Carlo simulations were performed to analyze the trajectory correction precision of different correction methods. Results show that the correction effect of impulse jet on lateral deviation is obvious,and the capacity of impulse jets correcting the longitudinal deviation is inadequate. The drag brake can reduce the longitudinal deviation significantly,and it can't eliminate the lateral deviation. The combined method is the best choice to decrease both lateral and longitudinal deviation,and the circular probable error can be improved to 28 meters. The above conclusions were validated by flight tests. The result shows that the combined trajectory correction method is effective. |
来源
|
弹道学报
,2020,32(1):38-46 【核心库】
|
DOI
|
10.12115/j.issn.1004-499x(2020)01-006
|
关键词
|
脉冲推冲器
;
阻力板
;
弹道修正弹
;
弹道仿真实验
;
飞行试验
;
落点散布
|
地址
|
陆军工程大学石家庄校区, 河北, 石家庄, 050003
|
语种
|
中文 |
文献类型
|
研究性论文 |
ISSN
|
1004-499X |
学科
|
武器工业 |
文献收藏号
|
CSCD:6692217
|
参考文献 共
18
共1页
|
1.
曹营军. 基于脉冲控制的末段弹道修正弹点火相位优化研究.
兵工学报,2008,29(8):897-901
|
CSCD被引
5
次
|
|
|
|
2.
杨红伟. 防空弹道修正弹脉冲执行机构的控制方法.
北京理工大学学报,2011,31(10):1184-1188
|
CSCD被引
3
次
|
|
|
|
3.
刘松. 弹体姿态调控引信系统设计与仿真.
兵工学报,2010,31(1):18-22
|
CSCD被引
3
次
|
|
|
|
4.
李超旺. 脉冲推冲器性能参数确定与试验验证研究.
现代防御技术,2015,43(5):77-82
|
CSCD被引
1
次
|
|
|
|
5.
常思江. 阻尼片横向弹道修正的落点预测方法.
弹道学报,2015,27(2):14-18
|
CSCD被引
2
次
|
|
|
|
6.
吴汉洲. 一维弹道修正弹飞行稳定性研究.
计算机测量与控制,2016,24(1):132-136
|
CSCD被引
3
次
|
|
|
|
7.
王巍. 多管火箭弹射击精度的复合形法优化.
哈尔滨工程大学学报,2014,35(9):1112-1116
|
CSCD被引
1
次
|
|
|
|
8.
贺军义. 提高多管火箭射击密集度设计技术研究.
振动工程学报,2011,24(6):676-681
|
CSCD被引
5
次
|
|
|
|
9.
王江. 脉冲直接力控制简易制导弹药命中精度研究.
系统仿真学报,2008,20(15):4176-4178
|
CSCD被引
3
次
|
|
|
|
10.
王钰. 摄动落点预测法的快速建模与基于精度最优的分段预测控制法.
兵工学报,2017,38(5):867-876
|
CSCD被引
7
次
|
|
|
|
11.
赵捍东.
脉冲发动机提供控制力的火箭弹弹道修正理论及技术研究,2008:49-89
|
CSCD被引
9
次
|
|
|
|
12.
盛启辉.
基于脉冲发动机的旋转火箭弹简易控制系统研究,2013
|
CSCD被引
1
次
|
|
|
|
13.
李超旺. 基于摄动原理的火箭弹落点实时预测.
兵工学报,2014,35(8):1164-1171
|
CSCD被引
10
次
|
|
|
|
14.
胡荣林. 确定射程弹道修正弹阻力器展开时刻的算法研究.
兵工学报,2008,29(2):235-239
|
CSCD被引
6
次
|
|
|
|
15.
史金光. 一维弹道修正弹气动力计算方法和射程修正量分析.
火力与指挥控制,2010,35(7):80-83
|
CSCD被引
6
次
|
|
|
|
16.
Philip V H. Predictive guidance of a projectile for hit-to-kill interception.
IEEE Transactions on Control Systems Technology,2009,17(4):745-755
|
CSCD被引
8
次
|
|
|
|
17.
Ravindra V C. Projectile identification and impact point prediction.
IEEE Transactions on Aerospace and Electronic Systems,2010,46(4):2004-2021
|
CSCD被引
16
次
|
|
|
|
18.
母文词. 某型火箭弹横向射击密集度分析及控制措施.
机械工程师,2014(3):240-242
|
CSCD被引
1
次
|
|
|
|
|