低黏度润滑油与织构对活塞环-缸套摩擦特性的影响
Effect of Low Viscosity Oil and Surface Texture on Friction Characteristics of Piston Ring-Liner
查看参考文献19篇
|
文摘
|
针对活塞环-缸套系统的摩擦行为建立了模型并进行数值求解,考虑了气穴现象和混合润滑的影响,研究了低黏度润滑油条件下织构对活塞环-缸套系统摩擦特性的影响,对比了在低黏度润滑油SAE0W20和SAE5W20的条件下活塞环表面含半径30μm、深度3μm的球形织构与不含织构的活塞环-缸套系统摩擦特性.结果表明:织构的作用与润滑油黏度密切相关;在润滑油SAE0W20的条件下,球形织构起到了一定的减摩作用;在润滑油SAE5W20的条件下,球形织构增大了系统的摩擦功率损失和摩擦平均有效压力. |
|
其他语种文摘
|
The paper built a numerical model for analyzing friction of piston ring-liner system,which considered the influence of cavitation and mixed lubrication.To investigate the synergistic effect of low viscosity and surface texture,two types of low viscosity oils,i.e.SAE0W20 and SAE5W20,were selected.Besides,the friction of piston ring with spherical texture,which was with a radius of 30μm and a depth of 3μm,was compared to the friction of piston ring without surface texture.The results show that the impact of surface texture is closely related to the viscosity of lubricating oil.Under condition of lubricating oil SAE0W20,the spherical texture helps to reduce friction,while under condition of lubricating oil SAE 5W20,the spherical texture increases friction power loss and friction mean effective pressure. |
|
来源
|
上海交通大学学报
,2018,52(5):505-510 【核心库】
|
|
DOI
|
10.16183/j.cnki.jsjtu.2018.05.001
|
|
关键词
|
活塞环-缸套系统
;
低黏度润滑油
;
表面织构
;
摩擦特性
;
混合润滑
|
|
地址
|
上海交通大学机械与动力工程学院, 上海, 200240
|
|
语种
|
中文 |
|
文献类型
|
研究性论文 |
|
ISSN
|
1006-2467 |
|
学科
|
机械、仪表工业;能源与动力工程 |
|
基金
|
国家自然科学基金
;
上海市航天科技创新基金项目
|
|
文献收藏号
|
CSCD:6257915
|
参考文献 共
19
共1页
|
|
1.
严新平. 船舶摩擦学的发展展望.
自然杂志,2015,37(3):157-164
|
CSCD被引
8
次
|
|
|
|
|
2.
邵林波. 汽车发动机润滑油的选用分析.
昆明冶金高等专科学校学报,2014,30(1):66-69
|
CSCD被引
1
次
|
|
|
|
|
3.
Lenauer C. Piston ring wear and cylinder liner tribofilm in tribotests with lubricants artificially altered with ethanol combustion products.
Tribology International,2015,82:415-422
|
CSCD被引
2
次
|
|
|
|
|
4.
李凯凯. 混合织构发动机缸套的减摩试验研究.
内燃机工程,2014,35(5):113-118
|
CSCD被引
4
次
|
|
|
|
|
5.
Macian V. Low viscosity engine oils:Study of wear effects and oil key parameters in a heavy duty engine fleet test.
Tribology International,2016,94:240-248
|
CSCD被引
5
次
|
|
|
|
|
6.
Tormos B. Fuel consumption and friction benefits of low viscosity engine oils for heavy duty applications.
Tribology International,2017,110:23-34
|
CSCD被引
6
次
|
|
|
|
|
7.
张慧慧.
面接触下表面形貌对动压润滑性能影响的研究,2013
|
CSCD被引
1
次
|
|
|
|
|
8.
李媛. 面接触条件下织构表面摩擦特性研究.
机械工程学报,2012,48(19):109-115
|
CSCD被引
19
次
|
|
|
|
|
9.
Grabon W. Effects of honed cylinder liner surface texture on tribological properties of piston ring-liner assembly in short time tests.
Tribology International,2017,113:137-148
|
CSCD被引
5
次
|
|
|
|
|
10.
Usman A. Optimizing the tribological performance of textured piston ring-liner contact for reduced frictional losses in SI engine:Warm operating conditions.
Tribology International,2016,99:224-236
|
CSCD被引
13
次
|
|
|
|
|
11.
Biboulet N. Analytical solution for textured piston ring-Cylinder liner contacts(1Danalysis).
Tribology International,2016,96:269-278
|
CSCD被引
4
次
|
|
|
|
|
12.
Obert P. The influence of oil supply and cylinder liner temperature on friction,wear and scuffing behavior of piston ring cylinder liner contacts-A new model test.
Tribology International,2016,94:306-314
|
CSCD被引
5
次
|
|
|
|
|
13.
乔姣飞. 表面织构对二硫化钼喷涂膜摩擦学性能的影响.
润滑与密封,2016,41(1):55-58
|
CSCD被引
4
次
|
|
|
|
|
14.
Qiu Y. Performance analysis of fullfilm textured surfaces with consideration of roughness effects.
Journal of Tribology,2011,133(2):021704-1-021704-10
|
CSCD被引
27
次
|
|
|
|
|
15.
Patir N. An average flow model for determining effects of three-dimensional roughness on partial hydrodynamic lubrication.
Journal of Tribology,1978,100(1):12-17
|
CSCD被引
273
次
|
|
|
|
|
16.
Woloszynski T. Efficient solution to the cavitation problem in hydrodynamic lubrication.
Tribology Letters,2015,58(1):18-1-11
|
CSCD被引
9
次
|
|
|
|
|
17.
Gu C X. Mixed lubrication problems in the presence of textures:An efficient solution to the cavitation problem with consideration of roughness effects.
Tribology International,2016,103:516-528
|
CSCD被引
5
次
|
|
|
|
|
18.
Greenwood J A. The contact of two nominally flat rough surfaces.
Proceedings of the Institution of Mechanical Engineers,1970,185(1):625-633
|
CSCD被引
206
次
|
|
|
|
|
19.
王素华. 基于表面织构的机械部件摩擦学性能改善研究进展.
机床与液压,2012,40(11):142-145
|
CSCD被引
4
次
|
|
|
|
|
了解气象卫星更多信息，请访问