淬火温度对7Ni钢低温力学性能的影响
Effect of Quenching Temperature on Cryogenic Mechanical Properties of a 7Ni Steel
查看参考文献19篇
|
文摘
|
使用OM、SEM、TEM和XRD等手段观察并表征在不同温度淬火的7Ni钢的组织形貌和逆转奥氏体含量的变化,研究了淬火温度对7Ni钢的低温强度和低温韧性的影响。结果表明:当淬火温度从830℃提高到930℃时钢的低温韧性急剧下降,低温抗拉强度和屈服强度明显降低。同时,随着淬火温度的提高延伸率下降,与低温强度的变化趋势基本一致。在830℃淬火的试验钢,原奥氏体晶粒和马氏体板条束最为细小。而当淬火温度超过830℃时钢中的原奥氏体晶粒和马氏体板条束都显著长大,钢的低温强度和低温韧性随着晶粒尺寸与板条束宽度的增大而下降,粗化的组织对钢的低温强度与低温韧性都有不利的影响。随着淬火温度的提高钢中的逆转奥氏体含量基本上呈下降趋势,在830℃淬火的试验钢中逆转奥氏体含量最高,其低温冲击功也最高。 |
|
其他语种文摘
|
The effect of quenching temperature on cryogenic strength and toughness of a 7Ni steel was investigated. The microstructure and volume fraction of reversed austenite were characterized by means of OM, SEM, TEM, XRD. Results show that cryogenic toughness of the steel sharply decreased when quenching temperature increased from 830℃ to 930℃. And cryogenic tensile strength as well as yield strength were obviously decreased with increasing quenching temperature. What's more, elongation also decreased at higher quenching temperature, and has a consistent variation tendency with cryogenic strength. Grains of prior austenite and martensite packets were fine in the steel quenched at 830℃, but grains and packets grew significantly at higher quenching temperature. Cryogenic strength and toughness decreased with growth of grain sizes and packet width. Coarsen microstructure has a adverse effect on cryogenic strength and toughness. The amount of reversed austenite showed downtrend basically by increasing quenching temperature. The steel quenched at 830℃ has a maximum of reversed austenite amount and impact energy. |
|
来源
|
材料研究学报
,2018,32(5):388-394 【核心库】
|
|
DOI
|
10.11901/1005.3093.2017.193
|
|
关键词
|
金属材料
;
7Ni钢
;
淬火温度
;
低温力学性能
;
微观组织
;
逆转奥氏体
|
|
地址
|
1.
中国科学技术大学材料科学与工程学院, 沈阳, 110016
2.
中国科学院金属研究所, 中国科学院核用材料与安全评价重点实验室, 沈阳, 110016
|
|
语种
|
中文 |
|
文献类型
|
研究性论文 |
|
ISSN
|
1005-3093 |
|
学科
|
金属学与金属工艺 |
|
文献收藏号
|
CSCD:6257740
|
参考文献 共
19
共1页
|
|
1.
刘佳丽. 中国LNG发展现状分析.
中国化工贸易,2015,34:42
|
CSCD被引
1
次
|
|
|
|
|
2.
Shaikh F. Assessing the stability of the LNG supply in the Asia Pacific region.
Journal of Natural Gas Science and Engineering,2016,34:376
|
CSCD被引
3
次
|
|
|
|
|
3.
Maki Yamashita. Development of 7%Ni-TMCP steel plate for LNG storage tanks.
Proceedings of the Asme Pressure Vessels and Piping Conference,2012
|
CSCD被引
1
次
|
|
|
|
|
4.
朱绪祥. 低C含7.7%Ni低温钢经两相区淬火后的组织性能.
钢铁,2013,48(11):72
|
CSCD被引
7
次
|
|
|
|
|
5.
杨跃辉. 两相区热处理过程中回转奥氏体的形成规律及其对9Ni钢低温韧性的影响.
金属学报,2009,45(3):270
|
CSCD被引
43
次
|
|
|
|
|
6.
Kim J I. Microstructural sources of toughness in QLT-Treated 5.5Ni cryogenic steel.
Metallurgical Transactions A,1983,14(1):93
|
CSCD被引
16
次
|
|
|
|
|
7.
路君. 晶粒度与合金强度关系.
轻金属,2008,8:59
|
CSCD被引
3
次
|
|
|
|
|
8.
雍岐龙.
钢铁材料中的第二相,2006
|
CSCD被引
401
次
|
|
|
|
|
9.
Swarr T. The effect of structure on the deformation of as-quenched and tempered martensite in an Fe-0.2 pct C alloy.
Metallurgical Transactions A,1976,7(1):41
|
CSCD被引
28
次
|
|
|
|
|
10.
梁宇. 原奥氏体晶粒尺寸对珠光体钢组织及韧性的影响.
材料导报,2017,31(1):77
|
CSCD被引
6
次
|
|
|
|
|
11.
Syn C K. Cryogenic fracture toughness of 9Ni steel enhanced through grain refinement.
Metallurgical Transactions A,1976,7(12):1827
|
CSCD被引
10
次
|
|
|
|
|
12.
Roberts M J. Effect of transformation substructure on the strength and toughness of Fe-Mn alloys.
Metallurgical Transactions,1970,1(12):3287
|
CSCD被引
21
次
|
|
|
|
|
13.
Wang C F. Effect of microstructure refinement on the strength and toughness of low alloy martensitic steel.
Journal of Materials Science & Technology,2007,23(5):659
|
CSCD被引
39
次
|
|
|
|
|
14.
张坤. 逆转变奥氏体对9Ni钢低温冲击韧度的影响.
材料热处理技术,2012,41(8):177
|
CSCD被引
1
次
|
|
|
|
|
15.
Hu J. The determining role of reversed austenite in enhancing toughness of a novel ultra-low carbon medium manganese high strength steel.
Scripta Materialia,2015,104:87
|
CSCD被引
26
次
|
|
|
|
|
16.
张弗天. Ni9钢中的回转奥氏体与低温韧性.
金属学报,1984,20(6):405
|
CSCD被引
29
次
|
|
|
|
|
17.
Yang Y H. Effect of quenching microstructure on the formation of reversed austenite in 9Ni steel.
Materials Science Forum,2014,788:277
|
CSCD被引
1
次
|
|
|
|
|
18.
Lee Y K. Effect of isothermal transformation temperature on amount of retained austenite and its thermal stability in a bainitic Fe-3%Si-0.45%C-X steel.
Scripta Materialia,2002,47(12):805
|
CSCD被引
17
次
|
|
|
|
|
19.
李员妹. 回火温度对5.5Ni低温钢组织和力学性能的影响.
材料研究学报,2015,29(11):860
|
CSCD被引
3
次
|
|
|
|
|
了解气象卫星更多信息，请访问