帮助 关于我们

返回检索结果

GCr15轴承钢热处理过程中碳化物的析出与演变行为
Precipitation and Evolution Behavior of Carbide During Heat Treatments of GCr15Bearing Steel

查看参考文献18篇

马超   罗海文 *  
文摘 采用定量金相的方法研究GCr15轴承钢在球化退火、奥氏体化淬火、低温回火等不同热处理工序后其碳化物的演变行为,通过ThermoCalc软件进行数值模拟计算分析碳化物尺寸和成分对其在奥氏体化时固溶动力学的影响。结果表明:球化退火处理后形成的碳化物粒子尺寸呈多峰分布,奥氏体化和回火后的碳化物粒子尺寸分布为单峰分布,奥氏体化后碳化物中Cr含量略有增加;Cr含量高的碳化物粒子具有较大尺寸;球化退火形成的碳化物在奥氏体化时大量固溶形成了富碳奥氏体,淬火后转变为高碳马氏体并导致高硬度;奥氏体化时碳化物固溶发生Cr的配分导致碳化物中Cr含量增加;直径200nm的碳化物即使其Cr含量接近基体成分,也不能在奥氏体化热处理时完全固溶,未溶的碳化物颗粒将影响后续回火过程的碳化物析出。
其他语种文摘 The evolution behavior of carbides in GCr15bearing steels after spheroidization annealing, austenitization quenching and low temperature tempering was investigated by the method of quantitative metallography.Numerical simulations on the dissolution kinetics of carbide size and composition during austenitization were performed by ThermoCalc software.The results indicate that the carbide particles formed after spheroidization annealing have a multimodal distribution whilst their size distribution changes to have a single peak after austenitization and tempering,and Cr content increases slightly after austenitization;the carbide particles appear to have larger size with higher Cr content;C rich austenite is formed during austenitization through solid solution by carbides after spheroidization annealing,and then high carbon martensite is formed after quenching and results in the high hardness; Cr atoms can partition from austenite to carbide during the dissolution of carbide,lead to the increasing Cr content of rest carbide particles;the numerical simulations indicate that the carbide particles with the diameter of 200nm cannot completely be dissolved during austenitization even if its Cr content is close to the nominal Cr content of steel,and the undissolved ones may affect the precipitation of carbides during the subsequent tempering.
来源 材料工程 ,2017,45(6):97-103 【核心库】
DOI 10.11868/j.issn.1001-4381.2016.001092
关键词 碳化物 ; 热处理 ; 固溶 ; 热力学 ; 动力学计算
地址

北京科技大学冶金与生态工程学院, 北京, 100083

语种 中文
文献类型 研究性论文
ISSN 1001-4381
学科 金属学与金属工艺
基金 国家国际科技合作专项 ;  “十三五”国家重点研发计划项目
文献收藏号 CSCD:6010754

参考文献 共 18 共1页

1.  王奇. 等温球化退火温度对高碳钢组织的影响. 金属热处理,2016,41(11):88-92 CSCD被引 11    
2.  余斌. 等温球化退火对某高碳钢中碳化物的影响. 金属热处理,2016,41(1):91-93 CSCD被引 7    
3.  黄超. 加热温度和保温时间对轴承钢GCr15SiMn碳化物的影响. 材料热处理学报,2015,36(4):156-161 CSCD被引 5    
4.  宋雯雯. H13钢中的碳化物分析及其演变规律研究. 材料热处理学报,2009,30(5):122-126 CSCD被引 28    
5.  张朝磊. GCr15球化珠光体组织在热处理过程中碳化物的遗传性. 材料热处理学报,2014,35(增刊1):45-48 CSCD被引 7    
6.  柴泽. GCr15轴承钢中碳化物的定量分析. 机械工程材料,2015,39(1):42-45 CSCD被引 2    
7.  Bhadeshia H K D H. Steels for bearings. Progress in Materials Science,2012,57(2):268-435 CSCD被引 128    
8.  Yamamoto A. Analysis of spherical carbides formed in chromium added hypereutectoid bearing steels. Materials Science Forum,2007,539/543:4866-4871 CSCD被引 2    
9.  马宝国. GCr15轴承钢中渗碳体的奥氏体化行为研究. 热加工工艺,2009,38(20):5-7 CSCD被引 3    
10.  杨洪波. GCr15轴承钢渗碳体球化的长大机制. 材料热处理学报,2012,33(8):79-83 CSCD被引 18    
11.  李辉. GCr15轴承钢热处理中纳米级碳化物的析出. 材料热处理学报,2014,35(增刊1):34-38 CSCD被引 2    
12.  孙艳坤. GCrl5钢棒材热变形后冷却工艺对显微组织的影响. 金属热处理,2011,36(12):9-11 CSCD被引 4    
13.  许磊. GCrl5轴承钢球化退火研究现状. 热加工工艺,2013,42(14):11-14 CSCD被引 9    
14.  郭林. 奥氏体化时间对GCr15轴承钢球化组织的影响. 钢铁钒钛,2013,34(1):99-103 CSCD被引 1    
15.  Zhang C. Heredity in the Microstructure and Mechanical Properties of Hot-rolled Spring Steel Wire 60Si2MnA during Heat Treatment Process. Journal of Materials Science & Technology,2013,29(1):82-88 CSCD被引 6    
16.  Xu L. Investigation on wear behaviors of high-vanadium high-speed steel compared with high-chromium cast iron under rolling contact condition. Materials Science and Engineering:A,2006,434(1/2):63-70 CSCD被引 11    
17.  Hwang K C. Effects of alloying elements on microstructure and fracture properties of cast high speed steel rolls:Part II.Fracture behavior. Materials Science and Engineering: A,1998,254(1/2):296-304 CSCD被引 20    
18.  Reed R C. Determination of the temperature dependence of the lattice parameters of cementite by neutron diffraction. Scripta Materialia,1997,38(1):95-99 CSCD被引 1    
引证文献 18

1 王飞云 热处理温度对新型马氏体时效不锈钢微观组织和性能的影响 材料工程,2019,47(6):152-160
CSCD被引 6

2 吕穿江 球化组织对AISI 420型钢淬回火特性及耐蚀性能的影响 工程科学学报,2019,41(9):1142-1151
CSCD被引 0 次

显示所有18篇文献

论文科学数据集
PlumX Metrics
相关文献

 作者相关
 关键词相关
 参考文献相关

版权所有 ©2008 中国科学院文献情报中心 制作维护:中国科学院文献情报中心
地址:北京中关村北四环西路33号 邮政编码:100190 联系电话:(010)82627496 E-mail:cscd@mail.las.ac.cn 京ICP备05002861号-4 | 京公网安备11010802043238号