|
|
等离子喷涂纳米和常规喂料WC—Co涂层在干摩擦和水环境中的摩擦磨损性能研究
Friction and Wear Behavior of WC-Co Coatings Sprayed by Nanoscale and Conventional Powders in Dry and Water Environment
查看参考文献9篇
|
文摘
|
采用大气等离子喷涂法分别以纳米和常规喂料制备出2种WC—Co涂层，在SRV摩擦磨损试验机上考察了2种涂层在干摩擦和水环境中的摩擦磨损性能．结果表明：在干摩擦和水环境中，纳米WC—Co涂层的摩擦系数和磨损率均小于常规WC—Co涂层；纳米和常规WC—Co涂层的磨损机制差异不大，在干摩擦下其磨损机制主要以粘着磨损、剥落和磨粒磨损为主；在水环境中，WC—Co涂层与Si3N4配副时的摩擦系数和磨损量较与不锈钢球配副时高，2种摩擦副的磨损机理有所不同，前者主要以剥落和疲劳磨损为主，后者主要以粘着磨损为主，伴有轻微的磨粒磨损． |
|
其他语种文摘
|
Atmospheric plasma spraying method was used to deposit nanoscale and conventional WC-Co coatings using nanostructured WC-Co powder and conventional WC-Co powder as feedstock, respectively. Tribology properties of the coatings was investigated on a SRV under dry and water environment. Results indicate that the friction coefficient and wear rate of nanoscale coating was lower than conventional coating mostly, the wear mechanism of both coating was similar. The wear mechanism when rubbed against steel ball was mainly adhesion, brittle fracture abrasive in dry friction. In water environment, the wear of the coating was controlled by brittle flake with fatigue abrasion. When Si3N4 ball was replaced by steel ball in water environment, the friction and wear rate was effectively reduced, the wear mechanism was mainly adhesion with some abrasive. Nanoscale WC-Co coating exhibits better tribology performance than conventional coating both in dry friction and water environment. In water environment, the friction and wear can be effectively reduced when rubbing against steel ball. |
|
来源
|
摩擦学学报
,2006,26(3):208-213 【核心库】
|
|
关键词
|
WC—Co
;
等离子喷涂
;
涂层
;
摩擦磨损性能
;
水环境
|
|
地址
|
中国科学院兰州化学物理研究所, 固体润滑国家重点实验室, 甘肃, 兰州, 730000
|
|
语种
|
中文 |
|
文献类型
|
研究性论文 |
|
ISSN
|
1004-0595 |
|
学科
|
机械、仪表工业 |
|
基金
|
国家自然科学基金创新研究群体项目
|
|
文献收藏号
|
CSCD:2448145
|
参考文献 共
9
共1页
|
|
1.
刘文艳. 陶瓷液压系统综述--目前液压发展的新方向.
机床与液压,1998,156(6):3-6
|
被引
2
次
|
|
|
|
|
2.
李剑锋. 等离子喷涂碳化铬-镍铬涂层的摩擦学特性.
摩擦学学报,1996,1(16):14-20
|
被引
1
次
|
|
|
|
|
3.
欧忠文. 纳米材料在表面工程中应用的研究进展.
中国表面工程,2000,47(2):5-9
|
被引
27
次
|
|
|
|
|
4.
You Wang. Abrasive wear characteristics of plasma sprayed nanostructured aluminartitania coatings.
Wear,2000,237:176-185
|
被引
3
次
|
|
|
|
|
5.
Zhu Y C. Tribology properties of structured and conventional WC-Co coating deposited by plasma spray.
Thin Solid Films,2000,388:277-282
|
被引
1
次
|
|
|
|
|
6.
Stewart D A. Abrasive wear behavior of conventional and nanocomposite HVOF-sprayed WC-Co coatings.
Wear,1999,225:789-798
|
被引
42
次
|
|
|
|
|
7.
Guilemany J M. Role of three-body abrasion wear in the sliding wear behavior of WC-Co coatings obtained by thermal spraying.
Surface and Coatings Technology,2001,140:141-146
|
被引
8
次
|
|
|
|
|
8.
叶雄林. 超音速等离子喷涂WC/Co纳米结构涂层性能研究.
中国表面工程,2004,64(1):31-37
|
被引
12
次
|
|
|
|
|
9.
贾均红. 青铜－石墨复合材料在干摩擦和水润滑下的摩擦磨损性能及磨损研究.
摩擦学学报,2002,22(1):36-39
|
被引
14
次
|
|
|
|
|
|
了解气象卫星更多信息，请访问