钆对NiAl-28Cr-5.5Mo-0.5Hf合金显微组织和力学性能的影响
Influence of Yttrium on Microstructure and Mechanical Properties of NiAl-28Cr-5.5Mo-0.5Hf Alloy
查看参考文献13篇
文摘
|
采用压缩实验研究了在应变速率为1.93×10^-3s^-1时随着温度的变化不同Y含量对铸造NiAl-28Cr-5.5Mo-0.5Hf合金力学性能的影响,同时,运用扫描电镜(SEM)及其能谱和X射线衍射(XRD)方法分析了合金的显微组织。结果表明,加入Y后,合金的显微组织随Y含量的增加而逐渐得到细化,表现为共晶团的数目增多,共晶团内的Cr(Mo) 纤维层间距减小,胞界处的Cr(Mo)减小;当Y含量达到0=.1%(质量分数)时,在NiAl和Cr(Mo)的相界处形成稀土化合物Ni17Y2和Al3Y,削弱了界面结合力,导致屈服强度和塑性下降。此外,压缩实验测得在不同温度下,0.05%Y含量的合金的压缩强度和压缩率优于其它Y含量的合金,所以适量Y可以改善NiAl-28Cr-5.5Mo-0.5Hf从室温到高温的强度和塑性。 |
其他语种文摘
|
The influences of yttrium on the microstruc-ture and mechanical properties of NiAl.-28Cr-5.5Mo-0. 5Hf alloy were investigated by using SEM, XR.D and compressive tests, respectively. The results show that the microstructure of alloys is fined gradually with the yttrium content increasing. This causes the more quantity of grain cells and the finer spacing between Cr(Mo) fibers as well as smaller Cr(Mo) rods. When 0.1% (mass fraction) yttrium and above is added in the matrix, the yttrium compounds of NinY2 and AI3Y form at the interfaces between NiAl and Cr ( Mo) phase, which leads in the decrease of the strength and ductility. In addition, at the strain rate of 1.94 X 10~(-3) s~(-1), the compressive strength and ductility of 0.05 % Y content alloy is superior to those of other al-loys over a range of room temperature to high tempera-ture. Therefore, the proper yttrium can improve the strength and ductility of this alloy. |
来源
|
中国稀土学报
,2002,20(2):146-149 【核心库】
|
关键词
|
稀土
;
NiAl合金
;
显微组织
;
力学性能
|
地址
|
1.
中国科学院金属研究所, 辽宁, 沈阳, 110016
2.
大连理工大学材料工程系, 辽宁, 大连, 116024
|
语种
|
中文 |
文献类型
|
研究性论文 |
ISSN
|
1000-4343 |
学科
|
金属学与金属工艺 |
基金
|
国家自然科学基金
;
国家863计划
|
文献收藏号
|
CSCD:1134567
|
参考文献 共
13
共1页
|
1.
Guha S.
Mater. Sci. Eng. A,1991,131:27
|
CSCD被引
12
次
|
|
|
|
2.
Darolia R.
Scripta. Metall. Mater.,1992,26:1007
|
CSCD被引
20
次
|
|
|
|
3.
Johnson D R.
Intermetallics,1995,3:99
|
CSCD被引
57
次
|
|
|
|
4.
郭建亭. 定向凝固NiAl合金的微观组织和高温力学性能Ⅰ.微观组织和韧脆转变温度.
金属学报,2000,36:1139
|
CSCD被引
7
次
|
|
|
|
5.
Cui C Y.
Mater. letters,2000,43:303
|
CSCD被引
11
次
|
|
|
|
6.
Guo J T.
Intermetallics,2001,9:28
|
CSCD被引
5
次
|
|
|
|
7.
George E P.
J. Mater. Res.,1990,5:754
|
CSCD被引
11
次
|
|
|
|
8.
Cosdandey F.
Scripta. Metall. Mater.,1992,26:723
|
CSCD被引
2
次
|
|
|
|
9.
Noebe R D.
International Mater Review,1993,38:193
|
CSCD被引
59
次
|
|
|
|
10.
王淑荷. 微量Y对铸造Ni_(50)Al_(20)Fe_(30)合金组织与性能的影响.
材料工程,1999(7):43
|
CSCD被引
3
次
|
|
|
|
11.
沙爱学. 镧与钢中磷的相互作用.
中国稀土学报,2000,18(1):52
|
CSCD被引
8
次
|
|
|
|
12.
庞绍平. 铈对Zn-22%Al减振合金组织和力学性能的影响.
中国稀土学报,2000,18(4):344
|
CSCD被引
4
次
|
|
|
|
13.
马鑫. 稀土对近共晶Sn60-Pb40软钎料合金凝固组织及高温力学性能的影响.
中国稀土学报,2000,18(2):135
|
CSCD被引
6
次
|
|
|
|
|